Aluma Protect 4400/4401, Blue, 2 Gallon Kit - Pettit Paint

This product has been discontinued.
Pettit Paint
Aluma Protect 4400/4401, Blue, 2 Gallon Kit - Pettit Paint
Your Price: $61.93 Discontinued
Save: $20.76
(25% Off $82.69)
Part # 4400/01Q ValueShip™ Eligible
No Reviews  |  Write Review  |  Ask Question
  • Smooth finish provides an excellent bonding surface for additional primers or topcoats.
  • Easy to apply.
  • Excellent water, chemical and corrosion resistance for aluminum surfaces.
  • High Performance Strontium Chromate Primer for all aluminum surfaces.

Aluma Protect is an epoxy primer specifically formulated for use on sand-blasted aluminum where maximum corrosion resistance to fresh and salt water is required. Coating is resistant to water, as well as, many chemical fumes and very humid environments.

Pettit Protect High Build Epoxy 4700/4701 is usually used over the Aluma Protect for bare aluminum, pontoon hulls, and outdrives.

Aluma Protect Aluminum Epoxy Primer 4400/4401 is a corrosion resistant, two component epoxy-polyamide coating for use on sandblasted aluminum where maximum resistance to fresh or salt water is required. The complete coating system is resistant to water, many industrial chemical fumes, and very humid environments. It is intended as a corrosion resistant primer coat for aluminum pleasure craft and has excellent durability in exterior exposures, although, like most epoxies, it will chalk if not topcoated.

Stir both components thoroughly. Mix the two components together in the ratio of 1 part of Component A to 1 part of Component B by volume. Allow to stand 15 minutes at approximately 70° before using. (Allow to stand at least 30 minutes if temperature is between 50° and 65°F) May be applied by brush, roller, conventional or airless spray. Thinning is not normally required for application, however, small amounts of 97 Epoxy Thinner may be used if necessary to facilitate application. Wet film thickness should be 3.6 mils per coat, which yields 1.0 mil dry film thickness. A wet film thickness gauge should be used to monitor paint application. One or two coats of Aluma Protect 4400/4401 should be overcoated with Pettit Protect 4700/4701 to provide a corrosion and chemical resistant barrier for use on all aluminum craft and surfaces.

Coating performance, in general, is proportional to the degree of surface preparation. Follow recommendations carefully, avoiding shortcuts. Inadequate preparation of surfaces will virtually assure inadequate coating performance. Degrease aluminum by wiping with 97 Epoxy Thinner. Sandblast, sand or grind the surface to achieve a good adhesion profile.

Disclaimer: Charts apply to Interlux products only. The information provided is not intended to be exhaustive. Because does not know how this information is being used, they cannot take responsibility for any actions as a result.

The performance of marine paint depends on many factors outside the control of, including surface preparation, proper application, and environmental conditions. Therefore, cannot guarantee this product's suitability for your particular purpose or application.

By purchase or use of this product, buyer agrees that the sole and exclusive remedy, if any, is limited to the refund of the purchase price or replacement of the product at's option.

Ask a question for
Question & Answer Guidelines
This product ships in 1 business day.
Add to Cart and enter your Postal Code to determine the shipping charges and estimated delivery date.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies