Back-to-Back Lounge Seat Weekender Series, White-Navy - Wise Boat Seats
Price: $195.98
Save: $59.01
(23% Off $254.99)
Part # WD1130-924
This item is found in the following Product Families

Weekender Series
Fish-N-Ski, Run-A-Bout Mix & Match Boat Seating Group

  • State-of-the-Art, High-Impact Plastic Frames
  • Vinyl Finish Molded Plastic Base
  • Scuff & Mar Resistant
  • Compression Foam Padding
  • Removable Seat Cushion for Storage
  • Heavy-Duty 28 oz. Marine Grade Vinyl
  • Mildew Resistant & UV Treated
  • 6 Year Warranty on Frame
  • 3 Year Warranty on Upholstery

Lounge Seat Dimensions

  • Height: 28"
  • Width: 18"
  • Length: 41.5"
  • Seat Depth: 14.5"
  • Length Reclined: 64.5"
  • Base Height: 10"
  • Base Width: 13.5"
  • Base Length: 36.25"

Full StarEmpty StarEmpty StarEmpty StarEmpty Star
Falling apart after 9 months
by Eric from Clearwater, Florida on July 07, 2015
I would like to downgrade my review of this item from 2 stars to one star. It has been 9 months since the seat has been installed, and it is just falling apart. The stitching is coming out.. they used non-stainless staples, and all of the staples are rusting... for 200 bucks I could have built my own seat, better, and that would have lasted. I am going to contact the manufacturer for a refund.
(5 of 5 people found this review helpful)
Was this review helpful?
Full StarFull StarEmpty StarEmpty StarEmpty Star
Poor quality
by Eric from Clearwater, Florida on October 06, 2014
ordered seat, was shipped fast, and arrived sooner than expected. (Nice job iboats). The seat itself, however, is in my opinion, extremely low quality, and even worse, just way too expensive for what you get. The base: is made out of injection molded plastic, slip locks together, and is overall, very flimsy. The mounting method causes the ends to slip and slide back and forth, even once the seat is fully secured. The only way to make it seem even reasonably secure, is place an additional 4 screws (one in each corner). Metalwork: Is ok, metal is a bit flimsy, and does not slide back and stow well. It is difficult to get it into the fully upright position. Screws are just zinc (as someone else mentioned, for the cost of this thing, it should have all stainless hardware!). Seat cushion/vinyl: Seat itself is some very high density foam, and is way too firm. Its like sitting on a board. They should have used a lower density foam for a better feel... I get they are trying to prevent it from collapsing, but this foam is just ridiculous. The vinyl is good. This is the only reason I upped the star rating to a 2 from 1. The vinyl is nice and thick, and the colors are very bright. Installation: was very easy, slide the pieces together, throw some screws in it, and done. Then fasten it to your boat however you see fit. Overall, for what this seat costs, I am regretting the purchase. I could have ordered Foam/vinyl... built in a better base, and made my own seat assembly for the same price (or less), and ended up with a much better product. This thing is worth at most 100 bucks in my opinion. Bottom line, if you want something quick and easy, its ok, but I still do not feel the value is there for the money.
(4 of 4 people found this review helpful)
Was this review helpful?
Full StarFull StarFull StarFull StarEmpty Star
Replacement boats seats
by Jessica from Smithfield, Rhode Island on August 14, 2014
The seats were delivered seven days after I purchased, The quality construction is decent for the price ,they were easy to assemble and look great. Jessica M Fox
Was this review helpful?
Full StarFull StarFull StarFull StarFull Star
by John from Supply, North Carolina on May 12, 2014
I need to replace my boat seats and am planning on doing it very soon. But as every one knows you have very little storage space in a boat. The seats I have know have a flap on the side for storage under the seat. That is were I keep my life jackets and first aid kit. If I order these seats do they have a way to store things under them? If you could send me a reply to my Yahoo account I would greatly appreciate it you should have my E mail account.
(0 of 2 people found this review helpful)
Was this review helpful?
Does this seat come in a wider size?
Not in the Weekender Series, but 8Wd1225-0034 is a lounge seat that is 20.25" wide.

Do you have seats that would fit in a 1993 Maxum boat specifically in white base with green accents and storage cushions?
We do not have a back to back that has a white primary color with green as a secondary color. The closest we have is white-teal, part number WD1033-0033.

Will this seat fit a 1989 celebrity se 182?
This is an aftermarket boat seat so it is not cross-referenced to specific boat models. It may fit a variety of models depending on the style and dimensions you are matching.

Our Grew is narrower than most of the current boats so we are needing narrower lounge seats. What is the narrowest that you carry ?
28" Wide is the most narrow lounge seat we carry on our site.

Does it fold into a bed?
It does not fold into a bed, exactly. It folds down into a bench style seat.

What is the base diamensions for this seat?
Base Height: 10" Base Width: 13.5" Base Length: 36.25"

Will these seats fit good in a 1982 17.5 malibu?
We cannot verify by your boat. You will need to know measurements and match up with this seat.

Will this fit a 1999 Bay Liner?
We sell after market seats. This will work on any boat as long as the dimensions will work in the boat.

1999 Bay Liner looking for all seats to be replaced?
We only offer aftermarket seats at this time, so you will need to know all the styles and dimensions of the seats needed.

How do the seats attach to the frame?
One side of the lounge seat is permanently bolted in place which only allows the lounge seat to open up in one direction.

I purchased the gray weekender seats. can I purchase the same matching fabric?
Yes. The replacement vinyl can be found at http://www.iboats.com/Wise-Marine-Vinyls-3-YD-order-minimum/dm/view_id.734113

Will this seat fit foe a 2005 larson 180 ski fish?
We do not have original information to cross reference. You will need to compare measurements or know dimensions needed.

I need 2 seats for my 1982 correctcraft southwind but need to know the dimensions of this seat and 2 swivel pedestals?
Here is the dimensions for this seat. Height: 26.5" Width: 20" Depth: 17.5" Please call in with part numbers for the swivel pedestals or start a question on the product page for the swivel your questioning.

Does it comes with the base and do you delever to Winnipeg Canada Canada?
It does not come with seat mount if that's what you mean by base, it's a standard 5-1/4" bolt pattern and can be mounted with a standard mount. Yes we do ship to Canada.

I ordered this seat in red and white do you sell matching vinyl red and white?
This is the vinyl for that seat series: http://www.iboats.com/Wise-Cuddy-Marine-Vinyls-3-YD-order-minimum/dm/view_id.734610

Can this seat be mounted on a swivel base in a 12 foot Alumacraft boat?
Yes, you should be able to mount those together.

Do you have anything close to 15.75" wide by 32" long.?
No, everything that we have is going to be much bigger than that at least length wise. Closest we have is 18" x 36.25", WD505P.

Ask a question
Question & Answer Guidelines
This product ships in 3 business days.
Add to Cart and enter your Postal Code to determine the shipping charges and estimated delivery date.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies

Please be careful when ordering this product, it has limitations that differ from our General 30-day Return Policy. After all, we want you to be satisfied with your order so you'll return again and again as an iboats.com customer, and to also recommend us to your boating friends

All seat returns are subject to a 15-25% restocking charge. The item(s) must be in clean and resalable condition otherwise the return will be denied.

See our complete return policy.