Keep Summer Going Strong with our August Sale Savings up to 50% OFF!

Deckhand Electric Anchor System - Minn Kota

Minn Kota
Your Price: $183.30
Save: $26.69
(12% Off $209.99)
Part # 1810125 ValueShip™ Eligible
SHIPS TOMORROW!* if ordered in 16 hrs 7 mins.
Hurry! Only 1 left in stock
No Reviews  |  Write Review  |  Ask Question
Your Price: $223.66
Save: $36.33
(13% Off $259.99)
Part # 1810126 ValueShip™ Eligible
SHIPS TOMORROW!* if ordered in 16 hrs 7 mins.
No Reviews  |  Write Review  |  Ask Question
Your Price: $249.48
Save: $40.51
(13% Off $289.99)
Part # 1810140 ValueShip™ Eligible
SHIPS TOMORROW!* if ordered in 16 hrs 7 mins.
Your Price: $309.70
Save: $50.29
(13% Off $359.99)
Part # 1810141
SHIPS TOMORROW!* if ordered in 16 hrs 7 mins.
Your Price: $36.31
Save: $3.68
(9% Off $39.99)
Part # 1810150 ValueShip™ Eligible
SHIPS TOMORROW!* if ordered in 16 hrs 7 mins.
No Reviews  |  Write Review  |  Ask Question
DeckHand automatically raises and lowers your anchor at the touch of a button Each model also features a special anti-drag system that senses the bottom to allow for controlled drifting.
DeckHand 25 Electric Anchor Winch - Minn Kota
DeckHand 25 Electric Anchor Winch - Minn Kota
  • 25-lb anchor capacity (anchor not included).
  • Pre-spooled with 60 feet of 800-lb test nylon rope.
  • Stow and deploy switch integrated into base of the unit.
  • Includes remote mountable anchor davit.
  • Auto-drift feature automatically stops the motor when the anchor touches bottom (or hits an obstacle); when slack in the rope becomes tight, rope is automatically released; lock the winch with the touch of a button.
  • Consistent hole pattern with older DeckHand ™ models (DH-18, DH-20, DH-35).
  • Runs on 12-volt battery (not included).
DeckHand 25R Electric Anchor Winch with Remote - Minn Kota
DeckHand 25R Electric Anchor Winch with Remote - Minn Kota
The DeckHand 25R's new 25-foot corded remote control lets you operate your DeckHand from anywhere on the boat
  • 25-lb anchor capacity (anchor not included)
  • Includes 25' corded control switch
  • Includes davit for stowing most styles of anchors
  • Pre-spooled with 60 feet of 800-lb test nylon rope
  • Runs on 12-volt battery (not included)
DeckHand Dh-40 Electric Anchor Winch - Minn Kota
DeckHand Dh-40 Electric Anchor Winch - Minn Kota
NOT FOR SALT WATER USE
Features:
  • 20- to 40-pound anchor capacity (anchor not included).
  • Pre-spooled with 100 feet of 800-lb test rope.
  • Auto-drift feature automatically stops the motor when the anchor touches bottom (or hits an obstacle); when slack in the rope becomes tight, rope is automatically released; lock the winch with the touch of a button.
  • Universal davit can be mounted at base of DeckHand™ or in remote position on boat deck; stows anchor horizontally to eliminate anchor swing.
  • Anchor shackle allows for easy changeover from anchor to anchor.
  • Stow and deploy switch integrated into the base of the unit.
  • Corded remote stow and deploy switch (sold separately) allows operation of DH-40 from anywhere on the boat.
  • Compatible with MKA-16-02 quick release bracket - ideal for easy removal for boat cover clearance or clearing the deck during non-use (requires holes to be drilled in top plate of quick release bracket).
  • 12-volt battery operation.
DeckHand 40 Pontoon Electric Anchor Winch with Remote - Minn Kota
DeckHand 40 Pontoon Electric Anchor Winch with Remote - Minn Kota
Our DeckHand Pontoon includes a MKA-16-02 quick release bracket and MKR-12 quick connect plug. Allows for fast, easy removal to clear the deck when needed. Also includes DeckHand 40 remote switch for convenient operation from anywhere on the boat. Anchor not included.
DeckHand 40 Remote Switch - Minn Kota
DeckHand 40 Remote Switch - Minn Kota
DeckHand™ 40 Remote Switch

Features:
  • Can be mounted in-dash, surface-mount or hand-held.
  • Plug-n-play design requires no additional wiring.
Full StarFull StarFull StarFull StarFull Star Based On 1 Review | Write Review
Full StarFull StarFull StarFull StarFull StarBack Saver
by Jerrad from Valentine, Nebraska on May 07, 2013
After pulling my lower back out twice hauling up my 28 lb anchor, I decided to get a deckhand 40 lb anchor winch. Being a fan of the Minn Kota products, I went with this brand. In order to install, the plastic cover has to be removed and is then hanging on by electrical wires that run from the winch motor to the switches. The cover was always in the way and so I just marked the wires and unhooked them to keep from damaging the wires and their connectors (I personally recommend). The wire connectors are simple male/female spade connectors so no cutting and splicing is needed. I had space the winch up 3 inches to clear the sides of the boat as the front deck on my boat doesn't sit flush with the sides. The mounting holes on the winch are a bit of a hassle as the holes are located under the winch parts, not allowing the bolts to be dropped straight down through the holes. Having to use the longer bolts to go through my 3 inch spacer, it was tricky getting the bolts in and through the holes. I've used it 2 times so far and have no complaints about the performance of the DH-40. It pulls the 28lb navy anchor up with no problems and keeps it firmly stored in place. One hit on the seller, My particular DH-40 was either a return or a demo. One of the philips head screw-heads holding on the cover was shelled out and I could tell that the cover had been taken off before. One wire was unhooked inside which didn't allow the anchor to be released (likely reason for a return). After figuring out where the wire went and connecting it, the DH-40 worked properly. I kept the unit regardless as it all worked properly.
(27 of 29 people found this review helpful)
Was this review helpful?
Full StarFull StarFull StarFull StarFull Star Based On 1 Review | Write Review
Full StarFull StarFull StarFull StarFull StarNot installed yet
by Sally from Oconto Falls, Wisconsin on January 14, 2015
Bought this for a pontoon we ordered. When it gets installed this spring,I'll give it a workout. I am not anticipating any problems.
(1 of 5 people found this review helpful)
Was this review helpful?
Q:
What gauge wire does it take?
A:
According to Minn Kota, it depends on how far you're extending it. Typically you have a 50 amp breaker and that requires a 10 gauge wire. If you're extending to 15 feet then go with 8 gauge wire. If you're extending 16-20 feet then use 6 gauge. Anything over 20 feet use 4 gauge.
Q:
Will this switchwork with trec 45sw winch?
A:
This works with Minn Kota's Deckhand 40 anchor winch.
Ask a question for
Question & Answer Guidelines
This product ships in 1 business day.
Add to Cart and enter your Postal Code to determine the shipping charges and estimated delivery date.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies
Save More Now and Keep the Summer of Boating Fun Going Strong!