1" Flanging Tool - Moeller
Price: $32.53
Save: $10.36
(24% Off $42.89)
Part # 020700-00
2nd Day Air for $2.99 More Eligible
Includes required flanges for drain tube installation.
Average Customer Review for 1" Flanging Tool - Moeller
Full StarFull StarFull StarHalf StarEmpty Star
Based On 3 Reviews | Write Review
Full StarFull StarFull StarFull StarEmpty Star
Not required, but useful
by David from Davidsonville, Maryland on June 14, 2014
You can peen drain tubes, but this tool makes it pretty much foolproof- even for a talented fool...
Was this review helpful?
Full StarFull StarFull StarFull StarEmpty Star
Learning curve
by Robert from Manchester, Pennsylvania on May 12, 2014
I replaced the drain tubes on a 17 Whaler sport. I did not use o-rings for this application, I sealed the ends with 3M 4200. I had a 6' length of .032 brass tubing and I am happy for the extra material for practice. What I learned.... I cut the tubing at least 1/2" longer than the length of the hole. Flair the first end with one die turned 180 degrees (flat) so it does not flair that end. Flare the one end. Slide the tubing into the drain hole and mark the tubing length 1/4" longer than the hole. Anneal straight end with a torch until it is cherry red and allow to cool slowly. I did not quench it in water. The second flair was made using the tool as directed. If one surface is not square to the hole, make sure you flair that end (annealed) last. Once that last flair is complete (and square) I used the round end of a ball peen hammer and pushed it against the end of the flair, working the high lip until it rolled over against the hull.
(2 of 2 people found this review helpful)
Was this review helpful?
Full StarFull StarFull StarEmpty StarEmpty Star
1" flanging tool
by Mack from Spartanburg, South Carolina on November 10, 2013
only works on 2" and thicker hulls any smaller and die faces touch before drain tube is tight need to shave off some of inner die face so it will work on thinner hulls.
(3 of 3 people found this review helpful)
Was this review helpful?
I am restoring a 13' Boston Whaler. ID of drain tubes are about 11/16" will your tube and tool work? Do I use standard "O" rings?
Moeller has never tested them with anything other than their drain tubes. So it might be able to work, but they said they only take into account outer-diameter measurements. So the 1" flanging tool will work with their 1" outer diameter drain tubes.

Ask a question
Question & Answer Guidelines
This product ships in 1 business day.
Add to Cart and enter your Postal Code to determine the shipping charges.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies