Manual CMC Power-Lift Jack Plate, 5-1/2" Setback

Made of 6061 T6 extruded aluminum alloy and fastened with stainless steel fasteners. It utilizes an all thread stainless steel screw centrally located for uniform lift and positive alignment. The motor bracket moves up and down on the transom bracket by use of rollers matched from aluminum-bronze alloy (same as hydraulic CMC Power-Lift). There is 5" of verticle adjustment, with 5-1/2" set back from transom. Designed to fit any standard motor up thru V-6, 300HP without drilling holes or making modifications. The Power-Lift provides the added convenience of adjusting from the top or the bottom.

Easy to use! Very strong. by Mark - Manteno, IllinoisJune 19, 2011

Never used one and have never installed one. Very easy to install. Very heavy duty. Up to 300hp. Test ran it several times to get the right height with my prop. Gained about 6mph on top end and excellent hole shot.

(4 of 4 people found this review helpful)

Was this review helpful?

Report as inappropriate

Deosn't work for me by Stephen - Babylon, New YorkMay 29, 2011

Hi, My new jack plate is a thing of beauty but my mechanic informs me that I don't have enough clearance to tilt the engine with my hynautic hydraulic steering. He says that every time I needed to tilt the engine I would have to crank the jack plate up to its maximum, then re set it for running. My boat is a 22' Velocity with a 200hp Johnson. Any ideas? I know if anybody is at fault it is me. Is this returnable? The heavy duty shipping box is gone. Should I mount it on my wall as a reminder to look before I leap? Thank you. Steve

(3 of 6 people found this review helpful)

Was this review helpful?

Report as inappropriate