Manual CMC Power-Lift

Made of 6061 T6 extruded aluminum alloy and fastened with stainless steel fasteners. It utilizes an all thread stainless steel screw centrally located for uniform lift and positive alignment. The motor bracket moves up and down on the transom bracket by use of rollers matched from aluminum-bronze alloy (same as hydraulic CMC Power-Lift). There is 5" of verticle adjustment, with a choice of 5-1/2" or 10" set back from transom. Designed to fit any standard motor up thru V-6, 300HP without drilling holes or making modifications. The Power-Lift provides the added convenience of adjusting from the top or the bottom.

Manual CMC Power-Lift Jack Plate, 5-1/2" Setback Part # 65012 Made of 6061 T6 extruded aluminum alloy and fastened with stainless steel fasteners. It utilizes an all thread stainless steel screw centrally located for uniform lift and positive alignment. The motor bracket moves up and down on the transom bracket by use of rollers matched from aluminum-bronze alloy (same as hydraulic CMC Power-Lift). There is 5" of verticle adjustment, with 5-1/2" set back from transom. Designed to fit any standard motor up thru V-6, 300HP without drilling holes or making modifications. The Power-Lift provides the added convenience of adjusting from the top or the bottom.

Manual CMC Power-Lift Jack Plate, 10" Setback Part # 61012 This unit has 10" of setback and 5" of vertical travel. It can conveniently be adjusted from the top or the bottom. Rated up to 300HP V-6

Easy to use! Very strong. by Mark - Manteno, IllinoisJune 19, 2011

Never used one and have never installed one. Very easy to install. Very heavy duty. Up to 300hp. Test ran it several times to get the right height with my prop. Gained about 6mph on top end and excellent hole shot.

(4 of 4 people found this review helpful)

Was this review helpful?

Report as inappropriate