Moeller Reed Switch Sending Units
The Moeller Reed Switch Sending Unit is designed to consistently provide accurate fuel gauge readings. This sending unit measures the fuel level position by the position of the float on the magnetic shaft, which means no electric parts in the fuel tank for added safety and peace of mind.
Features of Moeller Reed Switch Sending Units:
- Consistent and accurate fuel level information
- Stainless steel construction
- Direct OEM sender replacement
- Standard 33-240 ohms
- Standard 5 screw bolt on pattern with self sealing screws included.
- Rubber gasket made of fuel resistant compound for longer life.
- Comes in different sizes
- Dash mounted electric fuel gauge (035727-10)
- Gasket & screws replacement kit (035728-10)
About the Reed Switch Array for a Dash Mounted GaugeReed switch array sending units can be used with all gauge brands as it utilizes a 240-30 ohms range signal that is rated to BSP standards. An electrical signal is transmitted to a dash mounted gauge as the float determines the fluid level found in a tank. The signal is sent back by milliamps or ohms indicating an empty or full status on a dash mounted gauge.
Each unit is 100% tested at the factory prior to shipping ensuring the highest quality. The SAE hole patterned flange is designed to work with all style tanks with five holes. Constructed from 316 stainless steel flange and sensing rod it will provide years of use. These units are a direct OEM replacement for fuel tank manufacturers nationwide. Available is 21 different lengths ranging from 5.5” to 30.0” high tanks. Truly the best design to handle all fluid types from water, aviation, race and methanol or ethanol based gasolines.
Able to work with all forms of diesel, kerosene and other petroleum based engine fuels. Each unit come complete with a packet of five stainless steel screws with sealant on them and fuel resistant FKM nitrile rubber gasket. Installation is simple with removal of older unit verify length then replace with new sender.
Be certain to put gasket and tighten each screw till sealant comes out and two surfaces are leak free. Leak testing unit and assembly is critical and must be done before any use! No exception or any fuel tank installation work. Lifetime warranty on these units against manufacturing.