Features:- Fast dry.
- Superior adhesion to clean metals.
- 93% pure zinc in the dried film.
- Supplied in an easy to use aerosol spray can.
Spray can designed for protecting transducers.
General Description:
This product is for use only on bare metals such as steel, stainless
steel, cast iron, copper, bronze, galvanized steel and lead. It
forms an excellent adhesive bond to underwater metals and
running gear and inhibits corrosion on these surfaces. Because of
its smooth, hard surface it will self-clean in service. Zinc Coat can
be used above or below the waterline. Do not apply anti-fouling
paint over Zinc Coat. For metal above the waterline apply one (1)
coat of Pettit 6627 Tie-Coat Primer after the Zinc Coat has dried
for 2 hours. Follow with two (2) coats of Pettit Easypoxy Enamel.
The dried film of Zinc Coat contains 93% pure zinc.
Application Information
Shake can vigorously for one minute after mixing balls begin to
rattle. Shake often during use. Hold can upright 12 to 16 inches
from the surface and spray in a steady back-and-forth motion,
slightly overlapping each stroke. Keep the can the same distance
from the surface and in motion while spraying. Applying in thin
coats. Allow no more than 5 minutes between two or three thin
coats, otherwise allow to dry one hour before applying additional
coats.
When finished spraying, clear spray valve by turning can upside
down and spraying until no more paint comes out. If valve clogs,
twist and pull off spray tip and rinse it in a solvent such as mineral
spirits. Do not stick a pin or other object in the stem.
Surface Preparation
Remove all paint from underwater metals and runing gear by
sanding, scraping, sandblasting or by using a paint and varnish
remover. Once back to bare, clean metal wipe the surface with
Pettit 120 Brushing Thinner and let dry.
For application to metals above the waterline remove all paint and
rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Clean surface with Pettit 120 Brushing Thinner and let dry.
NOT FOR USE ON FIBERGLASS OR WOOD
Physical Data
Vehicle Type...Modified Epoxy
Finish...Flat
Components...1
Coverage...10 sq. ft/16 oz. spray can
Application Data
Method...Aerosol Spray
Number of Coats...2 or 3 Do not apply more than three coats as
cracking and loss of adhesion may occur if
product is applied too thick or in too many
coats.
Dry Film Thickness per Coat...1.5 mils
Thinners...120 Brushing Thinner; cleanup all overspray before it dries hard.
Disclaimer: Charts apply to Pettit products only. The information provided is not
intended to be exhaustive. Because iboats.com does not know how this information is being used, they cannot
take responsibility for any actions as a result.
The performance of marine paint depends on many factors outside the control of iboats.com, including surface
preparation, proper application, and environmental conditions. Therefore, iboats.com cannot guarantee this
product’s suitability for your particular purpose or application.
By purchase or use of this product,
buyer agrees that the sole and exclusive remedy, if any, is limited to the refund of the purchase price or
replacement of the product at iboats.com’s option.
