Ideal for protecting boats up to 33" in non tidal areas from damage caused by wind and wake.
These fiberglass whips act as a spring to maintain your boat at a safe convenient distance from your dock
Manufactured from solid fiberglass rod and wrapped in three additional multistage, cross wound fiber layers
Impervious to UV degradation, cold or heat
Unique line tensioner for easy, one handed operation
Please note that some areas are too rough for any type of mooring or tie up system
One complete set of Two Premium Mooring Whips
Mounting hardware and spring lines included * The exclusive "Plug & Socket" Design on these whips was developed by for quick and easy separation, allowing for convenient storage.
DockEdge Mooring Whip Video
Acts like a spring to maintain your boat at a safe distance from your dock. Ideal for protecting boats up to 33" in non tidal areas from damage caused by wind and wake. ...read more
Dockedge mooring whips protect your boat from damage by securely holding it away from the dock’s edge. Rough waters from passing boat traffic or natural causes harmlessly rock the boat instead of slamming it against the dock.
Installation is easy. Line up the whip bases with the 4 1/2 cleats on your boat. Drill pilot holes and secure the base with lag screws. Assemble the two sections of each whip making sure to twist the top portion so that it securely seats in the bottom section. Thread the lines through the top pulley and insert the whip into the base. Tighten the T-knob to hold the whip in place. Measure 18 inches from the base and install the cleat. Secure the free end of the mooring line around the whip cleat and fasten the looped end to the boat cleat as shown.
Now a simple pull of the free end of the mooring line will position your boat safely out of harm’s way. Make sure the mooring lines aren’t too tight or that the whips aren’t under too much tension. Properly adjusted whips hold the boat safely away from the dock.
Does 2 piece mean 2 complete whips? 2 tops 2 bottoms which would be 2 whips?
This set comes with 2 full mooring whips. 2 bottom pieces and 2 top pieces as well as all the mounting hardware necessary.