SeaStar Nfb Pro Rack (No Feedback) Dual Cable Steering System Package
The SeaStar NFB Pro Rack (No Feedback) Dual Cable Steering System Package is perfect for non-power assisted outboard boats up to 24'. This steering system features a patented no feedback steering mechanism that prevents driver’s fatigue. It also has a twin-cable that improves steering efficiency by minimizing lost motion within the system. The 4 turns lock-to-lock feature allows easy and precise steering control for high performance boats that experience instability due to engine flutter.
- Patented no feedback technology minimizes driver’s fatigue
- 4 turns lock-to-lock
- Precise steering control
The SeaStar dual cable steering system has cables in varied lengths as well as a standard 3/4" tapered steering shaft that allows for easy installation. The included stainless steel telescopic ram assures durability.
Features of the SeaStar NFB Pro Rack (No Feedback) Dual Cable Steering System Package:
- Patented no feedback technology
- Offers highly precise steering control
- Twin cables minimizes lost motion
- 4-turns lock to lock
- Minimal clutch free play
- Stainless steel cable output end
- Fits non power assisted outboard boats up to 24'
- Replaces standard Teleflex Rack without dash modification
- Meets A.B.Y.C. standards
- Meets N.M.M.A. certification
|How to Measure Steering Cables: |
"Measure Twice. Order Once."
Replacement of existing Cable:
For Rotary steering cable replacement, measure existing cable as follows: Measure plastic cable jacket in inches, add 18", and round up to the next foot. Order that length cable.
For Rack steering cable replacement, measure existing cable as follows: Measure plastic cable jacket in inches, add 30", and round up to the next foot. Order that length cable.
For New Installation: Measure cable routing path from wheel center to engine connection, as follows:
| A = Center line of wheel to gunwale (or deck, if routed downward), |
B = Dash to Transom,
C = Gunwale to centerline of cable connection at centered tiller.
For Cable Installations through Engine Tilt Tube:
Add A, B and C +6", then round up to the next foot. Order that lenth
For Cables Mounted to Transon, Splashwell or Stringer:
Add A, B and C, then subtract 6" and round up to the nest foot. Order
that length cable.
Cable routings (such as those found on pontoon boats) may vary
from this drawing. Confirm length by laying a garden hose along
cable path and measure run from wheel to engine connection point.