Ultima SR, Ablative Dual-Biocide Paint - Pettit Paint
- Dual Biocide, Multi-season Protection
- No yearly build-up of paint
- Relaunch without Repainting
Formulated to provide the best antifouling protection (using the dual biocide of copper and CIBA Irgarol), along with ablative technology which allows for controlled wearing away of the paint film. The continuous supply of fresh biocides eliminates build-up and keeps the hull smooth. Great for trailered boats and dry winter storage. Use Thinner 185.
All paint colors shown here are for guidance only. Due to differences in screen displays that are beyond our control the colors on these pages cannot be guaranteed to match the actual color in the can.
Ultima SR Ablative Dual Biocide Bottom Paint is an antifouling protective coating resistant to slime, algae, barnacles and other marine fouling. The high loading of cuprous oxide combined with an organic algicide offer unpredendented control over all types of fouling even in the most severe fouling areas. Ultima SR's unique controlled erosion minimizes coating build up and keeps underwater surfaces smooth and clean.
Ultima SR is heavily loaded with cuprous oxide. As a result of this loading there is a tendency for settling to occur, especially if the paint has been on the shelf for several months. It is necessary to thoroughly mix the paint before using. If possible, shake the can of paint on a mechanical paint shaker. Before using, check the sides and bottom of the can to make sure all the pigment has been mixed in. If mixing is going to be done with a wooden paddle or an electric drill mixer, pour off half of the liquid from the top of the can into another can and then properly mix in any settled pigment; then remix the two parts together thoroughly.
Adhere to all application instructions, precautions, conditions, and limitations to obtain optimum performance. Refer to individual labels and tech sheets for detailed instructions when using associated products, etc. Do not thin Ultima SR more than 10% (12 ounces per gallon) or inadequate paint film thickness will occur and premature erosion of the finish will be likely. Do not apply Ultima SR in thick films or in more than four coats as poor adhesion may result. When applying by roller use a short nap (3/16 inch maximum) roller cover.
Coating performance, in general, is proportional to the degree of surface preparation. Follow recommendations carefully, avoiding shortcuts. Inadequate preparation of surfaces will virtually assure inadequate coating performance.
No antifouling paint can be effective under all conditions of exposure. Man made pollution and natural occurrences can adversely affect antifouling paint performance. Extreme hot and cold water temperatures, silt, dirt, oil, brackish water and even electrolysis can ruin an antifouling paint. Therefore, we strongly suggest that the bottom of the boat be checked regularly to make sure it is clean and that no growth is occurring. Lightly scrub the bottom with a soft brush to remove anything from the antifouling paint surface. Scrubbing is particularly important with boats that are idle for extended periods of time. The selfcleaning nature of the coating is most effective when the boat is used periodically.
Disclaimer: Charts apply to Interlux products only. The information provided is not intended to be exhaustive. Because iboats.com does not know how this information is being used, they cannot take responsibility for any actions as a result.
The performance of marine paint depends on many factors outside the control of iboats.com, including surface preparation, proper application, and environmental conditions. Therefore, iboats.com cannot guarantee this product's suitability for your particular purpose or application.
By purchase or use of this product, buyer agrees that the sole and exclusive remedy, if any, is limited to the refund of the purchase price or replacement of the product at iboats.com's option.