Westland
Westland Self-Adhesive Snap Patch
Your Price: $14.99
Save: $12.05
(44% Off $27.04)
Part # 7035AP 2nd Day Air for $2 More Eligible
This item is found in the following Product Families
Self-Adhesive Snap Patch:

  • No need to cut a hole in the boat cover.
  • No sewing required.
  • Just peel and stick!

Boat cover support pole with snap end sold separately.

Average Customer Review for Westland Self-Adhesive Snap Patch
Full StarFull StarHalf StarEmpty StarEmpty Star
Based On 6 Reviews | Write Review
Full StarEmpty StarEmpty StarEmpty StarEmpty Star
Poor quality items
by Brandon from Raleigh, North Carolina on August 07, 2016
After less than 2 months usage, the snap buttons have come out from the adhesive patch on 2 of the 3 patches I purchased to place on my new cover from iboats. I was concerned about the strength of these patches and my concern was valid. At the $14 per patch cost, it was a an expensive lesson. I am very disappointed. My previous cover had sewn in patches holding the snaps and never wore out from 10 years of usage - unfortunately iBoats (nor other cover vendors) offer this option anymore.
Was this review helpful?
Full StarFull StarFull StarEmpty StarEmpty Star
Installation tricky
by Brandon from Raleigh, North Carolina on July 09, 2016
The patches (I bought 3) have very strong adhesive which is fine. Putting on the patches went ok until getting to the snap area. The paper backing did not want to separate at the snap and then once you get it to tear, it left a long section of paper behind the snap as you finish pulling the patch. I couldn't find a way to remove that paper effectively without getting the adhesive stuck to itself. Not sure how long the adhesive will stay attached to the new cover I purchased along with patches, or how tough the adhesive patch is. Will the snap eventually pull thru? It was the only option available, hopefully they will last a long time.
Was this review helpful?
Full StarFull StarFull StarEmpty StarEmpty Star
Thinner than expected
by Bruce from Novi, Michigan on June 30, 2014
This may work if your cover has a double thick reinforcement already. I expected it to be a thick material to spread the force over a large area, but it's paper thin and only intended to attach a snap to a fabric w/o adding a hole. So if it's installed on a single layer of cover it will probably wear through after time.
Was this review helpful?
Full StarFull StarFull StarFull StarEmpty Star
Snap Patch
by Randall from Apex, North Carolina on September 30, 2013
Use for one month, works fine, pull backing off in small sections to apply. If it touches itself it is next to impossible to straighten out. Use a razor blade and patience if this does occur. Good glue which is needed to adhere to the fabric. A recommended product.
(1 of 1 people found this review helpful)
Was this review helpful?
Full StarFull StarFull StarFull StarEmpty Star
snap patch
by William from Grayslake, Illinois on July 09, 2013
Product does what it supposed to do. Product is quite expensive though
Was this review helpful?
Full StarEmpty StarEmpty StarEmpty StarEmpty Star
careful
by Richard from Lethbridge, Alberta on May 30, 2011
Bought one, went to install it, followed the directions. The backing around the snap would not come off and in trying to remove the backing the sticky surface ended up stuck to itself and it all ended up in the garbage.
(8 of 8 people found this review helpful)
Was this review helpful?
This product ships in 3 business days.
Add to Cart and enter your Postal Code to determine the shipping charges and estimated delivery date.
Most products and orders leave our warehouse in 1 business day. However, select items may take more processing time. Alaska and Hawaii orders please add 1 additional warehouse processing day.
Standard Shipping Policies