Remove and separate the whole jet pump from the PWC.
Hold the front end of the drive shaft with a shaft holder on bench vise.
Remove the impeller. Turning clockwise will loosen the impeller.
Visually inspect thread on shaft & impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
Screw in the impeller by hand; be careful of the sharp edges of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
Assemble the pump and refill O/E pump oil or grease to spec.
*This installation guide is suggested for reference only. Please refer to your service manual for procedure details.
Guide for Yamaha 2005-Newer VX, VX Sport, VX Deluxe & VX Cruiser and 2006-Newer VX700
Remove and separate the whole jet pump from the PWC.
Remove the trail done (or cap) from the stator.
Hold the rear end of the shaft with a bench vise Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.
Visually inspect thread on shaft & impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
Screw in the impeller by hand; be careful of the sharp edges of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
Assemble the pump put it back on the PWC.
*This installation guide is suggested for reference only. Please refer to your service manual for procedure details.