Z-Spar Flagship Varnish 2015, Pint - Pettit Paint
- Recommended for the highest quality work
- Withstands severe weather conditions on salt or fresh water.
- Contains highest level of UV absorbers and light stabilizers for long-term gloss retention.
The highest Ultra Violet protection and superior gloss retention. Brushes, levels, and sands with the same outstanding characteristics as Captain's 1015. Can be built up to many coats for a deep, rich mirror-like finish.
Considered the traditional standard in the marine industry, this varnish is highly regarded for its reliable service, versatile application and tough yet flexible durability. It is blended with phenolic and alkyd resins and tung and linseed oils for excellent performance. It's warm, light amber hue will enhance the rich, classic brightwork appearance.
Z*Spar 2015 Flagship Varnish contains an ultraviolet light filter in conjunction with a hindered amine light stabilizer to screen the sun's damaging rays for longer life. Flagship Varnish has the highest build and film depth per coat, as well as excellent abrasion resistance and high gloss.
Do not shake varnish. Stir gently before application, being careful not to introduce air bubbles into the varnish. Z*Spar 2015 Flagship Varnish may be applied by brush or conventional spray. Thinning is not normally required although on warm days use Pettit 120/T10 Brushing Thinner at 5- 10% by volume to ease brushing and maintain good flow and levelling. In very warm weather (80°F and above) use Pettit 110/T11 Brush Flo Thinner at 5-10% by volume to maintain good flow and levelling. When spraying, use Pettit 121/T8 Spraying Thinner up to 10% by volume. Spray an even, wet coat to minimize orange peel. Do not apply Flagship Varnish on extremely humid days or when rain is threatening. Do not apply in the late afternoon when working outdoors as the wet film may be adversely affected by dew. DO NOT apply this varnish to a wood hull which has been dried more than one week under conditions such as artificial heat. Do not use Flagship Varnish below the waterline on boats that remain in the water. The moisture content of the wood should be a minimum of 15% when varnished. This will eliminate expansion cracking, micro-checking and gloss loss when the varnish is in service.
Wood must be clean, dry and properly prepared prior to varnishing. When sanding wood, always sand with the grain. Use a vacuum, air hose, or tack rag to remove all traces of sanding residue. Follow all surface preparation steps carefully, avoiding shortcuts. Inadequate surface preparation will virtually assure inadequate varnish performance.
Disclaimer: Charts apply to Interlux products only. The information provided is not intended to be exhaustive. Because iboats.com does not know how this information is being used, they cannot take responsibility for any actions as a result.
The performance of marine paint depends on many factors outside the control of iboats.com, including surface preparation, proper application, and environmental conditions. Therefore, iboats.com cannot guarantee this product's suitability for your particular purpose or application.
By purchase or use of this product, buyer agrees that the sole and exclusive remedy, if any, is limited to the refund of the purchase price or replacement of the product at iboats.com's option.