I have a 1994 150 HP Evinrude Intruder and the speedometer quit working. Did some checking and the speedometer hole which is located on the lower gear case unit, was stopped up with some trash. I took a piece of wire and cleaned out the hole to make sure there was no more trash obstructing the...
This thing is driving me crazy. I installed a new gauge (Tach or RPM, and still wont read all the time. I have checked all my wires both on back of gauge and at the wires that come off the stator or rectifier. I made sure the setting on the back of the Tach is set at 6 , what it calls for...
I put a new RPM gauge in, what do I set the marker setting on back of the gauge? I have a 1984, 115HP, V4 Evinrude. I think I have it wrong or the indicator is not set on the right mark. Gauge not acting right. Cleaned all my connections both at the motor and at the gauge. Would anyone know...
I have a RPM gauge that will read fine, then all of a sudden nothing. If you go a little more, then it will start reading again. I thought it was a faulty gauge so I changed the gauge out to a new one. Still does the samething. Off sometimes, then reads sometimes. Im thinking its a...
Have a 1984 Evinrude 115HP (E115TLCRD). Engine idle is too low even after motor has been running a good while. Engine dies when put it into neutral. Where is the adjustment for this?
