Serial 1C483844....40 ELPT.....I saw that design on the fuel pump where water went i one inlet and out to the tell tail I think....I figured I may have to buy a fuel pump....does this thing have a pressure sensor also that I should replace?
Got a 2017 40 4 stroke on a 13' Whaler, hit a sand bar...rather hard. Since then the engine has spit and sputtered at anything over 300 yards running at greater than 3500 rpm. I can run 3000 rpm or less no problem. Figured maybe the engine was clogged with sand so I removed the thermostat and...
Trying to replace the prop seals in my 200 EFI and the 4 inch nut that holds the bearing carrier in is froze solid. Got the special tool to use on it, applied heat, stood on the breaker bar, did not move a hair. Someone told me that the only thing I could do is drill the nut on one place and...
I have twin 1999 Merc 200 EFI's that I need to replace the prop seals in. Although I have never done it in an outboard engine, I do have experience replacing engine seals, just not in anything that would be run underwater. Is there any words of advice in doing this, any pointers that would help...
