Search results

  1. C

    Transom

    There are lots of videos on utube showing transom replacement. You might watch a few and get an idea what is involved.
  2. C

    Surprise My electric car is not charged.

    Around here the electric utilities sell backup generators. So if they screw up, you still have juice, and they make more $$. Gee I wish I could have made more money when I screwed up in business! On a related rant. I needed to raise my dock for the second time, as it was under water for a...
  3. C

    Seat covers

    Marine stores do sell them. There are not a lot of styles, however. Check Overtons, West marine and Amazon
  4. C

    Starter fluid everytime....

    It is doubtful that the ether damaged your engine. When the engine doesn't start, a 50::1 fuel solution is in the engine. Actually a lot of the gasoline has evaporated leaving the oil. As was said by post #12, a short a blast of ether will not harm a 2 cycle engine.
  5. C

    Advice for Portable Fuel Tank Mercury 115hp Command Thrust

    Makes sense for the timeframe. No pressure tanks on 115HP motors, right?
  6. C

    Advice for Portable Fuel Tank Mercury 115hp Command Thrust

    Gee, pressurized tanks were on the old Johnnyrudes, say mid 50's. By 1958 my Johnny Fat-fifty had a fuel pump and a regular fuel tank. I do not know if Mercury ever used a pressurized fuel tank. I would be surprised if Mercury made a 115HP motor with a pressurized fuel tank.
  7. C

    Trilobe Pin

    There look to be at least two different PTT systems you can have on that motor. The three ram PTT system should have the trilobe pin. The single ram PTT system doesn't. What do you have?
  8. C

    Starter fluid everytime....

    If you do use ether on any motor, make sure you have a fire extinguisher nearby. Ether can easily catch on fire from sparks that do not ignite gasoline vapor. A motor can seem to have no spark, and then whoosh! Ask me how I know.....
  9. C

    gamefisher manual

    Gee, wern't some Gamefisher's Mcculloch motors? I also thought some of them were Johnnyrude's. Just so you know, a lot of the Eska's had Tecumseh powerheads.
  10. C

    Data on Vintage Boat

    KBB usually has some of the info you want on boats. You probably need to determine the brand name, as I think you will need that to look it up.
  11. C

    Mercury 115 Tachometer Problem

    You need to test the yellow wires for AC voltage when the engine is running. So either stick the voltmeter leads into the yellow bullet connectors, and start the engine, or disconnect the yellow wires and test them with the engine running. If you find AC voltage on the yellow wires, the...
  12. C

    Mercury 115 Tachometer Problem

    Not sure that is definitive. A voltage test would help determine if the VR is good.
  13. C

    Mercury 115 Tachometer Problem

    The voltage drop when running is a bad sign. Did you check for AC voltage at the tach? If you get some, the stator is likely good. Depending on the year of the motor, it will have a rectifier, voltage regulator or perhaps both. Those are more likely to fail (and cheaper) that the stator...
  14. C

    Mercury 115 Tachometer Problem

    Check the voltage, ground and stator signal at the tach. Obviously the battery voltage is DC. Expect the stator signal to be AC. If the voltage jumps around, you likely have wiring issues. if the voltages are steady, the tach could be bad. They do not last forever.
  15. C

    1985 mercury 175hp starter sticking sometimes

    There is no way to know from your description. First remove the nut on the Bendix drive (above the gear that engages the flywheel). Remove the Bendix gear and clean the shaft with a mild solvent. Do not use acetone, toluene or other strong stuff as it will cause the starter windings to short...
  16. C

    1984 Sylvan Backtroller Floor & Foam Replacement

    If hull is aluminum, PT lumber is out, as is resin/cloth on the stringers.
  17. C

    Mercury 2.2 hp ignition coil

    Ign coil specs are usually nearly a dead short on the primary winding, and a whole lot more resistance on the secondary, but not open. Coils do not often fail. If you have a condenser, that is a prime candidate for replacement. Clean and properly gapped points are critical as is static timing.
  18. C

    VRO conversion to Fuel pump 1994 E60TLERV Evinrude

    Maxrules specializes in that conversion. They also have rebuild kits for the gasoline side of the OMS pump.
  19. C

    1984 Sylvan Backtroller Floor & Foam Replacement

    Make sure the stringers are sound. After the foam is poured, cured and trimmed, lay strips of poly resin saturated cloth on the stringers and screw the plywood deck to the stringers with stainless steel screws. Cover the plywood with at least two layers of light, saturated FG cloth, or one...
  20. C

    Restoring a trailer vs replacing a trailer

    You can always put a tube inside the trailer tires. That will seat the bead. The trailer tires I bought a year or so ago had the beads touching, and I could find no way to separate them and fill them with air. I forced on bead on, put a belt around the tire...all the usual stuff A tube fixed...
Top