Search results

  1. H

    1996 Mercury 25hp shortshaft lower unit replacement

    I need help locating the correct lower unit to replace or repair bent, twisted prop shaft. 1996 Mercury 25 M, Serial # 0G354154. If I repair myself, special tools are needed (?). What all is needed to be replaced, checked if I repair? Thank you guys.
  2. H

    1972 225 v6 timing issues

    This old Buick (OMC) engine was running wonderfully until recently. A mechanic friend believes the timing belt jumped and it's time to rebuild. Here's what's been done: Replaced condenser, points, plugs. (Wires fairly new and distributer cap looks good.) Here's the symptoms. Starts and runs at...
  3. H

    '72 OMC 155/225ci engine Cooling system plugs popped out-why?

    2nd run of the year, after 5 minutes of idle speed then, 3/4 throttle for 5 min, then idle for 5, 3/4 throttle again both these popped off flooding my stern. What might cause that and what do I need to do about it? Was this a blockage issue in the system? Perhaps I wasn't pumping any raw water...
  4. H

    Stringer electric shift won't go into forward.

    I was trolling for several hours at idle in my 1972 Steury V5-18 with the OMC 155. At one point a couple of hours into trolling at idle speed the gear slipped out very briefly and right back into forward. After we finished trolling, we accelerated and the gears slipped out of forward and would...
  5. H

    1972 OMC 155 I/O overheating positive battery terminal and feed to solenoid.

    Starter will not move when ignition key is turned. Left key in "on" position, and notice overheating positive battery terminals and hot wire that feeds starter solenoid. Solenoid was replaced 2 years ago. Checked terminal connections and battery selector connections, checked wires for breaks in...
  6. H

    1972 OMC Tilt clutch issue (again)

    I've searched this forum for more detailed information regarding the operation of the clutch plates but could not find such information. The outdrive is no longer supported by the clutch. I have installed a new electric motor which operated the system fine without the weight of the outdrive. I...
  7. H

    1972 OMC V6 155-Stuery V518

    1972 Steury V518. So this engine was tuned up last year and this year has started backfiring after WOT for 5 minutes or so. Engine pushes boat at around 33 mph then slows down a few mph then backfires once or twice while at full throttle. I back off the throttle and it continues to backfire...
  8. H

    '70's era Evinrude Sportwin 9.5 for kicker-prop help

    Are there any options for a higher thrust prop for this motor. I am pushing a 2200lb boat with the 9.5 and burn about 6 gallons of gas in 4.5 hours in 2 foot waves. Sounds like a lot of gas, but we were running the motor at maybe 2/3 throttle. This is a short shaft and set back on a kicker...
  9. H

    1975 Evinrude 9.5 Sportwin-High Thrust Prop?

    I am wondering if there is a high thrust propeller that fits this shaft? I am using the motor as a kicker on a 2200lb boat. The original prop is still looking good but we used about 6 gallons of gas in 4.5 hours running the boat at 1.8-2.0 mph in 2 foot waves. Any ideas?
  10. H

    Steering pulls hard to starboard at speed.

    1972 Stuery V518, 155horse OMC Electric Stringer. Finally getting this boat up to the point I can take it out on big water and get back to port. When I plane out the boat really pulls to starboard. If I were to let go of the steering wheel, it probably would spin all the way to the right and...
  11. H

    1972 OMC 155 Stringer-No reverse

    Great forum-thanks for all the helpful posts I've read about this issue. I have downloaded the repair manual someone was very kind to put out there. 1972 Steury V518, 155hp OMC. Electric shift. New boat to me. Put on water first time last year, reverse worked but motor would kill each time it...
Top