Search results

  1. brim_buster

    Old OutBoard Repair

    They have rebuild kits for your carb. If you venture out and buy one from Tecumseh you might have to modify it. I tried that ONCE.
  2. brim_buster

    Old OutBoard Repair

    The CED- models were made by Eska but your missing some more numbers. The 0568 isnt enough. You have a pic? They made a Seaking in 69 and in the early 80's. they made a 3.5,5,7,7.5.
  3. brim_buster

    Ward Sea King Service Manual

    Thats a 1962 made by Gale. Nice grab. Got any pics?
  4. brim_buster

    Ward Sea King Service Manual

    Check your private messages. I sent you a message
  5. brim_buster

    Late 60's McCulloch 4 hp

    I sent you a private message
  6. brim_buster

    Dt150 alarm

  7. brim_buster

    Dt150 alarm

    Throttle position sensor or TPS
  8. brim_buster

    1957 Firestone 3.6 hp (Scott-Atwater) Restoration

    I had to red coat the inside of the tank because of the rust but it did the job.
  9. brim_buster

    1957 Firestone 3.6 hp (Scott-Atwater) Restoration

    This is the one I did and got it to run. Alot of hard work as you know and I love it. Yours turned out Amazing as well. Gave me goose bumps to see yours. Fantastic job
  10. brim_buster

    1954 Montgomery ward seaking 5hp question

    yes sir. Pull the side cover off and look at the pistons. See if they are scored or if rings are broke. Very easy to replace pistons and rings without removing flywheel or crank. The gasket kit for the whole motor isnt expensive either.
  11. brim_buster

    1954 Montgomery ward seaking 5hp question

    Thats mighty low
  12. brim_buster

    1954 Montgomery ward seaking 5hp question

    Thats one of the first things you do. Compression check. If you didnt know the Gale division of outboards is the exact same as evinrude and johnson. A spin off of OMC. Alot of interchangeable parts. Probably nothing wrong with the carb. Your 2 knobs get turned in to seated and back out 3/4 of a...
  13. brim_buster

    1954 Montgomery ward seaking 5hp question

    When you turn the twist grip throttle control does the butterfly open in the throat of the carb
  14. brim_buster

    1963 Eska Golden Arrow flywheel key

    https://www.ebay.com/itm/124607044458?hash=item1d03289b6a:g:ZtUAAOSw9jNgPoig
  15. brim_buster

    Sea King Serial # location

    post a pic with and with out the cowling
  16. brim_buster

    78 Gamefisher 7.5HP Weak Spark !?!?

    Thats what a solid state motor looks like when you pull the flywheel. If thats the case then either the SSI is weak or you have a bad wire or something going on
  17. brim_buster

    78 Gamefisher 7.5HP Weak Spark !?!?

  18. brim_buster

    78 Gamefisher 7.5HP Weak Spark !?!?

    First of all is it a points motor or solid state? Do you have a model or serial number? What parts are you looking for?
  19. brim_buster

    Gamefisher 3hp gear lube?

    If you dont see drain plugs it takes grease. Lubiplate. Yours should use oil. The 2.5hp had a drain plug behind the prop.
  20. brim_buster

    Gamefisher 15hp

    Look to see if it has a tell-tale hose or a pisser. Thats where water would come out of. Your motor is a 1996. Im gonna search a video and see. Ok watched a video it has a tell tale and water should flow out a hose on the back lower cowling. So if you dont see that check your hose and check the...
View older results
Top