Had a similar thing on a mercruiser. It would thump no matter what gear or neutral. Alignment was good, u-joints and gimble replaced, even tried two other drives. The problem continued. We were the third shop to look it over. I moved on to a different job so I'm not sure where the issue was, but...
Pull the drive, pressure and vaccume check it. Many times its the shift shaft seal thats leaking, hopefully its that wich is an easy fix. You will have to split the drive to replace that seal.
Did you just remove the lower half? Usually removing the entire drive is easier. You have to put the shifter in to full forward to remove and replace the drive. The shoe in your pic isn't straight forward, so that might be your issue.
I use coarse/medium/fine stones in that order depending on how dull the blade is. Freehand. I only use water on the stones, when done let them dry and put away. I prefer water as its readily available and when out hunting I keep at least the fine stone in my backpack for touch ups if needed...
There are wiring codes for marine use. But if someone has been in there before, wich usually is the case, nothing will match up to the codes. Here's one example.
Marine Wire & Terminal Tech Specs | Boat wiring, Boat, Color coding (pinterest.com)
You could pull it with a three jaw puller or cut it off. I think you need to test fit the new one in the housing and see how tight it fits. Also did you remove the retaining in on the outside of the bearing? If its not there its going to be loose.
If you have someone in the area that has some time on their hands, and knows a bit about mercruiser's it would be helpful to have them take a look. Jumping into an i/o right off the bat is a bit intimidating. Most of what I am seeing is almost easy for me, but you have to know what does what. If...
If you truly have a fuel leak, I'd be looking for the source. Also its mixed with water? If the cover isn't leaking, you might have the foam filled hull saturated with water. What year/type of boat is it?
It's a trailer queen. Sort if. I wouldn't bother putting bottom paint on if it's not left in for extended periods of time. I'm doing mine without bottom paint, if its an issue later I'll put it on. But I'm in freshwater.
Just recalled from back in the day.... In tech school me and a buddy rebuilt the transmission in his moms car, road tested just fine. Cleaning up drain pans, found a thrust washer Laying there. What to do..... She drove that car for another eight years without issue. Stuff happens.....lol
Just...
