Search results

  1. C

    Wont Start. Johnson 1979 25hp

    Removing a plug causes it to spin fast enough. Take the battery to a auto parts place to be LOAD TESTED. Post the results of the test. Needed
  2. C

    slight gas in oil 2009 yamaha 4 stroke

    Honda car engines also make oil. Honda says idle a cold engine a lot longer to warm it up more completely. They ALSO recommend driving for a long time every month. To really heat up the oil completely. After doing a interstate run at 70 mph the oil level on the Dip Stick drops a 1/8" lower.
  3. C

    115 v4 2 stroke runs rough when warmed up

    Only time I ever saw 3 run times look like that. COLD running engine due to stuck open thermostat. My own engine.
  4. C

    1985 Johnson 120hp poor idle/starting

    C D I Oh well. You have adjusted Idle mixture and idle speed screws correctly ? You seem to have 2 separate problems ? Low speed ? Hot engine stoppage ?
  5. C

    Need help with strobe timing on 1972 9.5 HP Johnson 9R72M

    The smoke can also be steam. Overheated thermostat operation. Some cooling inlet water holes being blocked off. Can you post pictures of sparkplugs ? Or how bad black build up is ?
  6. C

    115 v4 2 stroke runs rough when warmed up

    Those plugs are a good part of erratic engine power. Install CORRECT new ones. Those may be wrong type.
  7. C

    CDI Electronics and AGM Battery Compatibility

    Well now we know why so much of their equipment does not work or last very long. They knowingly create problems. To increase more sales.
  8. C

    Boat trailer bunk bracket question

    I have just used long enough 2 " wide by 6 8 or 10" wood beams Beveled to fit flush on boat bottom. Or cut all the bevel to lay flat on the trailer rails. Either way works fine. Some of us just used flat Aluminum plates about 3" by 5" to secure the beams to the frame.
  9. C

    tahoe 1950 trailer guide pole

    I had a commercial Electrical Contractor use his hydraulic pipe bender to bend 4 Aluminum heavy walled pipes in to L shapes. Then auto store for exhaust pipe clamps. For clamping to the trailer frames. The pipes allow 1" of clearance to boat rub rails. They work great in brown muddy water...
  10. C

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    Never said this before. Possible bad casting molds or process.
  11. C

    CDI Electronics and AGM Battery Compatibility

    NEVER EVER put anything between the cable compression lug surface and the cleaned LEAD POST surface. The washer goes between the nut surface and the lug surface.
  12. C

    CDI Electronics and AGM Battery Compatibility

    What are you getting ? At different levels of battery capacity ?
  13. C

    12 ft aluminum boat max hp

    How many people ? How heavy is each 1 ? Weight in a 12 footer. Is all important. Next in importance is hull width.
  14. C

    Nobody fishing?

    I accept that the fall fishing trips. Will become sunny boat rides more often. :)
  15. C

    CDI Electronics and AGM Battery Compatibility

    You are looking into my small boat Battery Box. :)(y)
  16. C

    CDI Electronics and AGM Battery Compatibility

    What happens to CDI garbage when the alternator is recharging a slightly run down battery ? KABOOMM ? I tried CDI on my old Evinrude's Rectifier. Always failed new and after 1 long run at WOT. Other boating friends had similar repeat failures.
  17. C

    What does HEI / D.U.I. replace

    Would feel terrible if it is the key switch. Or even the LARGE plug and connector pins on top of the engine. Those split pins do get intermittent connections to all of the engine electrical parts with age. Have someone pull apart & reconnect the connector several times. The try the key start to...
  18. C

    Onboard Battery Charger

    Most chargers will now show amount of power with solid green dots. Then show flashing light for the balance to reach 100 %.
Top