Search results

  1. C

    Air silencer cover

    I lost my carburetor FACTORY black plastic Air Noise reducer. A 2 stroke is very NOISEY without that part. :sick:
  2. C

    Tahoe 1950 Deckboat - fish finder overheat

    Friend has a overheating F F way out of warranty. Oh well.
  3. C

    Nobody fishing?

    Time to buy another pack of lures. :)
  4. C

    Need with what Battery is needed

    Post #20 is all I do with the 1986 30 hp motor. I just did a FULL 4 hour recharge at 10 amps 2 days ago. After 6 ? years of winter storages in upstate N Y. No trickle charge. Just read 12.5 volts on rested battery. It was at 12 .3 right out of winter storage. A careful 10 amp charge rate...
  5. C

    Priming rebuilt carb

    Thank you Scott. (y)(y)
  6. C

    Excessive "play" in Sea Star hydraulic steering

    Company says your operation is NORMAL !!! Unit is GARBAGE !! I have no idea what to suggest. Good luck with that dog. Edit..... I would use a different power steering setup. Before someone needs to do a sudden evasive turn.
  7. C

    Considering buying this1989 15hp. New to outboards and wondering if anyone could let me know if it sounds like it's running well?

    Last few inches are slower ? Should just be a little too LONG of a recoil start cord.
  8. C

    Beeps when battery turned on

    Sounds like a tired battery that charged up. What ran the battery down ? Something left on ? Like a Bilge Pump and Float switch ? Some are very quiet. If covered by a engine or floor boards. Radio with volume way down. I have done those and a lot more. Fish Finder & Bow lights. Several times.
  9. C

    Priming rebuilt carb

    When you add the Primer bulb ? Do not remove it. That way you will always have a spare way to keep the engine running. If the pump dies in the middle of nowhere at Midnight.
  10. C

    Buy a used block will parts swap?????

    Hope is not going to make a successful swap. Accurate examination by a experienced mechanic on both engines is needed at this time. Nothing less will do.
  11. C

    Priming rebuilt carb

    I have a 14' fuel line. Squeeze the rubber black ball until it becomes firm and round. Carb is then fully primed.
  12. C

    B is for boat guy.

    (y)
  13. C

    Yamaha 9.9 wierd choke-ish behavior

    Dying fuel pump . Or watery gas collecting in the carburetor.
  14. C

    Hydrolocked VP 3.0 GSP-A

    A good marine mechanic is next.
  15. C

    Johnson 90 Oops it did it again

    Are you sure your motor used up 3 gallons going to the boat launch ? The Choke valve would need to be almost closed for that usage to happen. Check all of your Choke linkage and Thermostatic Coil for correct action when cold and hot.
  16. C

    6hp 1971 Evinrude, worth getting?

    At that age ? Use it until it fails. We have brand new motors waiting for brand new parts. Mix the correct oil and oil ratio. Carry a NEW correctly gapped sparkplug and sparkplug wrench. Enjoy reliability. As you tow a new boat & motor to shore. It happens.
  17. C

    Johnson 90 Oops it did it again

    Anybody else have a sinking float ? It would take 15 to 30 minutes to fully kill the motor. Some are really odd balls. Both Varnished cork floats. And the molded foam floats. Fun days. Using the oars for over 1 hour. :)(y) Reminds me to check the oars & refinish them.
  18. C

    Where do you get your parts?

    Used motors that need GOOD new or good used parts ? Lots of luck and web searches.
  19. C

    Engine alignment

    Without real FACTORY FIT tolerances ? I would be happy with that. Grease as specified in called out places. I lubricate all male and female grooves VERY carefully. With a stiff paint brush. Pushing grease into all the bottoms of the grooves. I do remove the excess amounts.
  20. C

    Yamaha Sterndrive 5.7l Overheating

    What did you use to get the accurate 200 F temperature readings ? The temperature instruments may be going bad also. If truly 200 F exhaust ? You will see STEAM coming out of the exhaust water when idling. Been there. Few rocks & impellor parts ?? How can a thermostat handle that stuff & work ?
Top