Search results

  1. C

    Nobody fishing?

    With beer and drugs for breakfast. No speed is too fast.
  2. C

    1976 888 Fuel Questions

    Sadly it is a old poorly maintained motor before you bought it.
  3. C

    2000 25hp 3cylinder Johnson getting hot.

    Do the different rpm / temperature tests in the lake. Those are the only temperatures that count. Check each sparkplug for a clean look.
  4. C

    Yamaha T50 won't exceed 3500 rpm

    You need a GPS handheld to get ACTUAL speed in the water. Corrected for any river currents. Low wind speed. Less than 5 mph. How accurate is the boat tachometer ?
  5. C

    New issue cropped up on my transom/bunk position!

    The boat is supposed to be FULLY supported by the centerline KEEL SUPPORTS ONLY. The outer supports should be just slightly loose under the hull.
  6. C

    2000 25hp 3cylinder Johnson getting hot.

    Thermostat or gasket missing ? I once FORGOT to install a thermostat. Stuck open ? Way too cool of a thermostat ?
  7. C

    Intermittent Start Issue

    Why I carry a set of 18' long car jumping leads to isolate any erratic starter problems. Handy to jump another boat with a weak battery.
  8. C

    Constant ringing noise from throttle when motor is running.

    Evinrude had that same condition. Motor over heat sensor in the cylinder head was stuck in the overheat condition. I pulled the wire connector apart at the sensor. No more alarm. Replaced the overheat sensor. Still great.
  9. C

    New issue cropped up on my transom/bunk position!

    Almost every Aluminum boat with small OB on them. Do put a piece of Marine grade plywood between the outside transom skin and the inside transom Aluminum skin. That piece of plywood SPREADS out all the bending & twisting stresses of the motor ay W O T.
  10. C

    Screeching noise on my 1967 3hp

    Starting a engine with no water in the pump housing is the fastest way to a melted impellor blade.
  11. C

    90 hp carb over filling

    Plastic carburetor parts were installed to provide repair money for the dealers.
  12. C

    New issue cropped up on my transom/bunk position!

    The left side of the transom bottom is being crushed by water rotted wood inside of the transom. It should be the same thing on the right side of the transom bottom. behind that massive white plate. Old boats do die.
  13. C

    What gives with helping people with a problem ?????????????

    And........ Oh no. Not again Mr. Bill.
  14. C

    Gas - Oil Mixture on old Evinrudes outboards

    There is only 1 way for a D I Y person to ...Completely ...mix the 2 liquids together. And KNOW they are protecting the engine from friction wear.
  15. C

    Gas - Oil Mixture on old Evinrudes outboards

    YAWN
  16. C

    Boat to store inside garage ?

    Size always matters. (y)
  17. C

    Time for Riser & Manifold > VP or Barr?

    2 headless studs are great when removing or installing a starter motor or a transmission.
  18. C

    How often to replace points ignition?

    I am 86 and have repaired & maintained them without problems. I have NEVER NEVER had to replace them. Only when I FIRST started to HOP UP the family car did the points become damaged !!!!!!!!!!! A real mechanic repaired my screwing up the points. Points can and USUALLY last forever. If...
  19. C

    Dash got ripped out!

    Do NOT FORGET ...all....those oddball sensors you have to use . Or convert to the different gauges.
  20. C

    130 v4 tach question

    Many many thank yous for posting the solution.(y):)
View older results
Top