Search results

  1. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Looks good, and after the bottom paint goes on and motors installed, folks will be looking at the motors
  2. alldodge

    Boats from work.

    nice rig, and nice work
  3. alldodge

    Artificial Intelligence

    Have used both and have a slight feel better toward Claude but it want's to start charging. Gemini seems to be just fine but also noted that it misses things, and I've trained it some for my questions
  4. alldodge

    Volvo penta Gi-G (2006)

    Then 40 +/- 4 psi
  5. alldodge

    Mercruiser Coil Wiring

    Depending on how it's wired it could be ok
  6. alldodge

    extremely high idle suddenly

    I would look first at the throttle control, something could be binding or not moving as it should
  7. alldodge

    Volvo penta Gi-G (2006)

    Thanks for the Gi-G but need to know what motor? One beep ever 5 seconds does log a code, it's weird because the ECM is saying there is a problem For excess fuel would be good to check pressure Gi 4.3, 5.0 = 29 psi +/- 2 Gi 5.7 = 50-60 psi Gi 7.4 = 39 psi +/- 3
  8. alldodge

    Crusader Counter Rotation #1 Spark Plug Location.

    Depends on which cam was installed, I'm finding where dizzy rotates different and where they rotate the same. Crank the motor and watch the rotor
  9. alldodge

    Trail camera issues fixed, now pics....

    I know without pics it didn't happen but I have seen 2 sets of fawns with Mom's in our front yard
  10. alldodge

    Mercruiser Coil Wiring

    Do some really good tracing because from here things are not correct. My pic for a standard TBV has 2 gray on the Neg, and one purple on the Pos. The Yel and Blue should not be there. Having a Blue on the Pos side of the coil would lead me to believe a different oil pressure switch has been...
  11. alldodge

    Mercruiser Coil Wiring

    You have a TBV ignition and the prior owner is a dumb A$$ Remove the resistor mounted on the boat Get the correct coil, inspect your wires as they may need replacing, than go boating
  12. alldodge

    VP 5.7 TBI bogging down

    Should be 30 psi with TBI Take the fuel filter off and dump the contents into a clear container to make sure there is nothing but clear clean gas
  13. alldodge

    Oil pressure switch / oil pressure sender

    As your state the filter is not done correctly. With it connected this way there is no filtering of the fuel and any crud is pump straight through to the carb Does look like it needs a pump and the pump filter hose moved to the the other port, then clean the carb
  14. alldodge

    Mercruiser 454 I Need Help Identifying This Engine

    Look below the distributor on the block deck for the casting number Then see if the number comes up in this link https://www.mortec.com/bbc.htm
  15. alldodge

    Dual battery or booster pack?

    If combined for a few seconds it will increase the current and also the better Bat will be able provide more voltage, which is normally enough to start a motor from weak Bat.
  16. alldodge

    electricians? Breakers, GFCI, AFCI

    I've rewired several homes, mine and sisters over the years, all passed inspection. I learned a lot from my Dad which was an electrician. I've never done a complete house in probably 20 years now. I did wire my new barn and it passed, but a barn does not require the same kind of inspection
  17. alldodge

    electricians? Breakers, GFCI, AFCI

    No electrician here but it's my understanding that there are GFCI and AFCI breakers. Current code The 2020 NEC® states that Arc-fault circuit-interrupter protection shall be provided as required in 210.12(A), (B), (C), and (D). The arc-fault circuit interrupter shall be installed in a readily...
  18. alldodge

    Oil pressure switch / oil pressure sender

    The GL series motors use switches to apply a ground to turn ON the alarm, they have nothing to do with spark or fuel Your motor uses a relay to energize the fuel pump. The pump is energized from power supplied by a Yel/Red wire coming from the key while cranking going thru a diode. The run side...
  19. alldodge

    Very short dock lines

    Looks like 1/4 inch clothes line not 3/8
  20. alldodge

    I/O (Sterndrive) Conversion to Outboards

    I'm seeing a change not in previous rendering. Is the angle piece going to cause some spray after water leaves trim tabs?
Top