Shieldsflex II Marine Water/Exhaust Hose with Wire

3-1/2” ID.
4” OD.
Has a black synthetic rubber tube and cover.
It is reinforced with wire helix imbedded between plies of HD synthetic cord.
This hose is abrasion and odor permeation resistant.
It now has double the ozone resistance required by the SAE J2006.
Shieldsflex II is primarily used for engine intake, wet exhaust connections (use where bends or long lengths are required), bilge pump intake/discharge, scupper lines, toilet intake/discharge, and holding tank vent/pump out.
The temperature ranges from -20° F – +200° F continuous, +250° F intermittent.
The hose meets SAE J2006 Type R2 standards.
Bend Radius = 5 x I.D.
Length 6-1/4’.

More Information

Shieldsflex II Marine Water/Exhaust Hose with Wire - Hardwall (3-1/2” ID)