Rust on driveshaft splines VP 2000 SX-M (Photo)

cmyers_uk

Senior Chief Petty Officer
Joined
May 4, 2004
Messages
760
S/n 4202006908 SX-M 1.66 Yr 2000 VP Outdrive.

Removed the drive for the winter found rust on the drive shaft in small area. See Photo :

http://gallery.me.com/chrismyers#100001/IMG_6283&bgcolor=black

1) No rust on universal joints or sign of water damage
2) No water in bellows, bellow appeared seats and sealed.
3) No sign of water in the grease in gimbal bearing
4) Splines were well greased at beginning of season and drive came off no issues.

It appears the rust is just in the area between a few inches after the gimbal bearing and where the splines go into the engine.

Where should I start looking for this issue?

Regards

Chris
 

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
71,138
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

Ayuh,....

That's the little bit of the shaft that's exposed inside your boat....

I don't think you Have an issue...
 

cmyers_uk

Senior Chief Petty Officer
Joined
May 4, 2004
Messages
760
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

So just clean it off (it was only surface rust) cleaned up fine and grease better next year?

Thanks Bond-o

Chris
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

Yes, just clean it up. If you want, you can even paint the exposed area of the shaft from the splines to where the taper for the orings starts. Then it won't rust. Or, just spray your engine compartment with corrosion guard. I really like the VP stuff. Spray everything that can rust.
That's one of the best things you can do with any saltwater boat.
When it drives, it's a waxy coating that keeps the engine shiny and not sticky.
 

cmyers_uk

Senior Chief Petty Officer
Joined
May 4, 2004
Messages
760
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

Many thanks , consider VP Corrosion Guard ordered. Good to know its not more serious issue.

Many thanks

Chris
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

A hint when using that corrosion guard.
Put it in a pan of hot water, (Not boiling, just out of the tap) for a while till the contents warm up a bit. Sprays a lot more even.
 

JustJason

Vice Admiral
Joined
Aug 27, 2007
Messages
5,321
Re: Rust on driveshaft splines VP 2000 SX-M (Photo)

that tip works epecially well with spraybombs too.
 
Top