Whats up guys, I rebuilt a center console 21ft'er,i redid the boat from the hull up. I got a 1987 Everude Johnson 150cc V6 outboard and it had a VRO but the people who had the boat previously had taken it out. I cant get the motor to run smoothly.
The main problem now is the motor is "Spitting" so when its idling and/or i am hold the revs at consistent RPM in both neutral, forward or reverse it "Spits" and/or sounds like one cylinder is missing. I have been searching around and read tons of posts but no solutions have fully worked for me. I checked compression, spark, the gas, carbs(3), adjusted the choke, and also check to see if there was water getting in the cylinders. The carbs seem to be in sync aswell. All these tests have failed to show that it was the problem. I am totally stumped if anyone has some good ideas id appreciate any information! There is alot of new parts/cables/and connections, im assuming that there is maybe minor adjustments with cables?idk
Here is a you-tube video of what the motor is doing, its not the best vid but if you watch it and look at the smoke u can see it spit and you can hear the motor misfire if you listen close or have good speakers. This video was taken during my gasoline test, i thought maybe the gas was bad but i guess not.(running it at 50-1 / regular gas)
Youtube Video:
http://www.youtube.com/watch?v=EpvcSVzClMA
Here's what i replaced/upgraded to the boat:
- All new spark plugs
- Cleaned and re-aligned floats in all 3 carburetors
-all new gas(including 2 separators
-2 new thermostats
-1 power Pack
-Replaced defective spark plug wires
-All new Ignition coils
-All new throttle Cables
- redid faulty motor wires on the harness
-rebuilt the Impeller
-New Batteries
-Whole new Center Console setup(gauges/throttle ect.)
- Im sure i forgot some stuff.
The main problem now is the motor is "Spitting" so when its idling and/or i am hold the revs at consistent RPM in both neutral, forward or reverse it "Spits" and/or sounds like one cylinder is missing. I have been searching around and read tons of posts but no solutions have fully worked for me. I checked compression, spark, the gas, carbs(3), adjusted the choke, and also check to see if there was water getting in the cylinders. The carbs seem to be in sync aswell. All these tests have failed to show that it was the problem. I am totally stumped if anyone has some good ideas id appreciate any information! There is alot of new parts/cables/and connections, im assuming that there is maybe minor adjustments with cables?idk
Here is a you-tube video of what the motor is doing, its not the best vid but if you watch it and look at the smoke u can see it spit and you can hear the motor misfire if you listen close or have good speakers. This video was taken during my gasoline test, i thought maybe the gas was bad but i guess not.(running it at 50-1 / regular gas)
Youtube Video:
http://www.youtube.com/watch?v=EpvcSVzClMA
Here's what i replaced/upgraded to the boat:
- All new spark plugs
- Cleaned and re-aligned floats in all 3 carburetors
-all new gas(including 2 separators
-2 new thermostats
-1 power Pack
-Replaced defective spark plug wires
-All new Ignition coils
-All new throttle Cables
- redid faulty motor wires on the harness
-rebuilt the Impeller
-New Batteries
-Whole new Center Console setup(gauges/throttle ect.)
- Im sure i forgot some stuff.
