Flywheel magnet locations 200hp looper

[SlingSteel]

I have a 1986 Johnson 200hp looper.
I had 1 or more magnets come loose and make a mess of the rest of them.
Got the flywheel all cleaned up. Before I epoxy the new magnets is there a location that I need to start at?
I know the spacing is 7/16" but does it matter where I place them?
I figure it must play a big part in timing and firing.

Thanks

 

[clanton]

Re: Flywheel magnet locations 200hp looper

Start anywhere. There is a top and bottom.

 

[nymack66]

Re: Flywheel magnet locations 200hp looper

Here you go Bud ..Its why we are here to help...
http://cdielectronics.com/downloads/troubleshooting guide/OMC Flywheel Trigger Magnet Location.pdf

 

[SlingSteel]

Re: Flywheel magnet locations 200hp looper

Thanks nymack66 for the link.

Now what is it showing me?


I see the key slot (12 oclock) and I also see slots at 7 & 11 oclock on otter edge of the picture?
But were do I place the first magnet to the picture, sorry if its a dum question. I just do not want to screw it up.


I'm looking at the V4 & V6 loop charge 1986-1987

Thanks

 

[Dhadley]

Re: Flywheel magnet locations 200hp looper

That's showing the center hub magnet location for the various years and models. You're talking about the outer magnets. As long as they're spaced evenly and orientated the correct / same direction it'll be fine.

 

[SlingSteel]

Re: Flywheel magnet locations 200hp looper

Thanks

That makes sence