Ok, so I picked up this engine that has sat for who no hows long but previous owner said 10+ years. Question I have is about the position of the three carbs on the intake manifold. Currently the fuel supply line from the fuel pump goes to one main carb and then by vacuum I assume it is drawn to...
Took boat out a few weeks ago and everything ran well. Went out last night, motor started right up, put in gear and off we went for a 6mph ride then full open for about 10 minutes. Seemed "to me" that power was not as stong as last year and throttle did not have much of a response past half...
Hi All,
Please let me know if someone can help. I am putting back together the Thermostat & Cylinder Head Cover on a new Head for a 1973 65 HP Evinrude.Triumph and I really want to confirm the torque values before I bust another bolt. Based on the book I have once the Thermostat and Cylinder...
Since boating season is done for a while here in my area I am on a hunt for a new/used cylinder head for a 1973 65HP 3 cylinder. Model # of the engine is 65ESL73R and I believe the model # for this part is 0317194. My spark plug holes are shot, already tried the Heli Coil approach and while...
Please bear with me on this. I have a 1973 Triumph 65HP 3 cylinder that today I started up in hopes of going out fishing tomorrow. Motor stared right up, great. But after it ran for a while I was looking over the motor and noticed the threads that hold one of the main bearing bolts on the port...
Bought a 73 MFG Gypsy with a 65 Triumph on it about two years ago for about $700 for fishing and crabbing. Boat has been out of the water for about 2-Months now and when draining the lower unit today the oil is coming out green like split pea soup. Oil came out cloudy last year but it was not...
Can Someone help me identify this part/parts in the picture and advise how difficult it is to replace. Engine is a 1973 Triumph/Evinrude 65HP 3 cylinder. Boat & Engine are new to me, took out for 2nd run of season to test and then all of the sudden I could not go more then 6-10 mph with...
Hi All, just picked up a 1973 MFG Gypsy with a 65 Evinrude last weekend for fishing and crabbing in Maryland. Take a look at the posting below from ebay.
http://cgi.ebay.com/ebaymotors/?cmd=ViewItem&_trksid=p3984.m1423.l2649&item=300647074025&sspagename=STRK%3AMEWAX%3AIT
Have a little bit...
