idles great, forward fast is great, problem is just when it comes off of idle and shifting to forward and when it is put into reverse, it doesnt always climb in rpm as well as it should. sometimes it wants to die in reverse. doesnt die when it is forward and cruising. always fresh gas and oil...
friend has one in need of a motor. cannot seem to find what brand the tilt and trim is. any help with a repair shop or a site to find the answer or fix the problem? thanks.
a mechanic told me that the rectifier may be bad since I checked and tested switch, and wiring, and it is on its third powerpac (not all by me). Is this possible? I performed the test on rectifier with a digital elec volt meter tester. this is what I got. <br /> <br />yellow grey to ground...
I am going to use a tach from a friend. he never used it and it came with his motor. want to check my idle speeds and running speeds/rpms. there is a dial on the back that goes from 1 (I believe), all the way up to 6. is this for the number of cylinders of the motor? thanks for any help.
doesnt miss a beat when tooling around the lake. but upon start up, and letting it warm up some, I find it hard to gradually shift forward or reverse from idle. I have to raise rpm with warm up lever and as I move lever back down and rpms slowly lower, I have to shift and it takes off without...
upon taking apart the lower unit housing, the water tube guide hold down bolt that screws into impeller housing fell out of the lower unit housing. threads are fine. screws in fine. should I put thread sealant on it, or torque it down. thanks.
been posting a bit but had to cover new info and a new question. first upon replacing my impellor with new one along with new impellor plate, I see the impellor plates are slightly different. the one I removed is stainless and has an "M" stamped on it along with 70 h(p)stamped, cant read the P...
1979 evinrude 75 hp. switch will not stop engine, have to choke it off. previous owner, had trouble also, switched key switch, I replaced power pack, same thing. any suggestions. thanks.
