Recent content by 1fast6

  1. 1

    1999 200 mariner

    disregard thread....:D
  2. 1

    need help reinstalling lower unit

    Changed my water pump now I can't get lower unit back on. It was in nuetral when I took it apart. So now the drive shaft spline is not lined up and when I spin prop it doesn't spin driveshaft. How can I get the lower unit into gear so the shaft will turn with prop?
  3. 1

    where to start?

    I have a 99 carbed mariner 200 that is having an overheat issue. Boat will run all day just off idle or on plane on glass. Once I hit moderate chop above 3,000 rpm it will set steady over heat alarm. I don't know when the water pump was last changed so that is getting done regardless. Could...
  4. 1

    what type of set up is this?

    I just bought this boat and I am working on changing out all the bad pumps and electric motors. I am not familiar with live wells and such so I drew up a quick sketch of my set up. I am getting a replacement pump tomorrow. As far as I can tell there is a drain in the bottom that goes to side of...
  5. 1

    maybe a sensor??

    Took the boat out last week and the overheat warning came on twice. Both times I turned off engine and restarted. Warning stayed off. Took out yesterday and went about 10 miles up the coast, pissin good, running good. Went into a channel, puttered around and then came back out of channel. Got...
  6. 1

    best place to buy

    looking for a replacement motor for my insta trim system. Looked on iboats but only found solenoids and hose. I need the motor. Thanks
  7. 1

    Random Pics

    Thought maybe we could start a random pics thread. Clean of course. here's a few
  8. 1

    1967 boston whaler

    Not sure where to put this but my brother has a 1967 13' whaler with the original 40hp evenrude. runs like a top. boat has been restored. Thinking about selling it but not sure what it's worth.
  9. 1

    leaving my mark...

    Bought my 1st boat about 8 years ago(03 bayliner 175:redface:) Was pulling it out of the water from our maden voyage and heard this grinding, scraping noise:eek: and felt alot of vibration in my truck:eek:..... Yeah, I forgot to trim:redface: Left a nice gouge in the boat ramp but no damage to...
  10. 1

    need help finding a part

    Working on a 99 mariner 200XL. The part I am looking for is a molded hose that conects from the engine to the plug in the cowling for hooking a water hose to. I can't seem to find it on any of the merc websites. Thanks for any help.
  11. 1

    eManuals on ebay

    Anybody buy one of the eManual cd's from ebay? Are they any good?
  12. 1

    Mariner question

    Just picked up a 99 legacy sea era with a 99 200 mariner offshore. Had a question about cooling system. 1st. the ''pressure'' guage on the dash, is that for water pressure in the cooling system? If so what kinda pressures am i looking for? 2nd. Took it out today and the overheat alarm came on, I...
  13. 1

    flushing a 200 mariner

    nevermind...
See more
Top