Current visitors

Home
Members

2004 searay's latest activity

2
2004 searay posted the thread need help identifying a 25hp motor in Mercury & Mariner Outboards.

hi , i have a motor with the id info tag empty so i do not know how to identify it and order parts. anyone know what serial # range this...
Jun 18, 2025
2

2004 searay replied to the thread lower shift shaft positioning for gear selection.

is it possible this a reverse rotation drive?

Jun 7, 2025
2

2004 searay replied to the thread No Spark, feels like I’ve tried everything..

so the problem was a DOA new distributor? firing order or timing is way off 1342 clockwise

Jun 7, 2025
2

2004 searay replied to the thread No Spark, feels like I’ve tried everything..

here is a great video, you should pull your dist and coil and run this test, once you confirm you have spark on a bench, then you can...

Jun 5, 2025
2

2004 searay replied to the thread No Spark, feels like I’ve tried everything..

at this point i think you should be looking at that new distributor/module. its possible it was DOA most good auto part stores can test...

Jun 5, 2025
2

2004 searay posted the thread best way to repair gimbal hing pin threads? in Mercury MerCruiser Sterndrives & Engines.

i have a gimbal helmet that has the threads ripped out and i am in need of repairing it. will the helicoil hold up to the torque spec...

May 24, 2025
2

2004 searay replied to the thread alpha one shift shaft alignment issue.

so i swapped out the lower shift shaft and it appears the issue is down below cause the replacement shaft lines up the same as the one...

May 14, 2025
2

2004 searay replied to the thread alpha one shift shaft alignment issue.

yes , both are in full forward and it is not going to 12:00. thats the issue, it wont go full straight on with the stud. i have tried 3...

May 9, 2025
2
2004 searay posted the thread alpha one shift shaft alignment issue in Mercury MerCruiser Sterndrives & Engines.

hey there., so i have this gen 1 drive with a shift shaft that when in forward is off by about 1/8-1/4 inch. it just does not line up...
May 9, 2025
2

2004 searay replied to the thread gears make a ratchetting sound after replacing shift/throttle cables, 2010 F150TXR.

im one person, cant hold the camera at the motor and shift it as well. the throw is full ,fwd & rev. when the linkage is connected , i...

May 2, 2025
2

2004 searay replied to the thread gears make a ratchetting sound after replacing shift/throttle cables, 2010 F150TXR.

i did this in the videos

May 2, 2025
2
2004 searay posted the thread gears make a ratchetting sound after replacing shift/throttle cables, 2010 F150TXR in Yamaha & Suzuki Outboards.

hi all, i have this Yamaha f150 that i replaced the cables on because the jackets were split. i installed OEM YAMAHA replacement cables...
May 1, 2025
2

2004 searay replied to the thread dpsm outdrive holds pressure after seal repair but not vacuum..

so your saying he should install the drive on the boat, fill it with fluid, run it for 15 minutes, drain it again and pull a vacuum...

May 1, 2025
2

2004 searay reacted to Scott Danforth's post in the thread dpsm outdrive holds pressure after seal repair but not vacuum. with Like.

install it and go boating

May 1, 2025

Show older items

Home
Members

Top