Recent content by 2BALL

  1. 2

    run a ground wire

    what wire do I use, size and type?
  2. 2

    run a ground wire

    can it be just 1 ground wire? from one light (ground) to the other light (ground) to the ground wire to the front? or do the need to be separate?
  3. 2

    run a ground wire

    Can I just run a ground wire from each rear light to the ground at the front of the trailer? Do I need to use the frame as the ground run? I'm goofing with a intermittent bad ground.
  4. 2

    Clip for wiring harness

    just realized when I redid my trailer lights, the kit came with the end of the wiring harness that goes on the vehicle. I can just zip tie that to the trailer and plug into that.
  5. 2

    Clip for wiring harness

    yes, I need that but for a four prong connector. looking now.
  6. 2

    Clip for wiring harness

    I want to put a clip on my trailer near the coupler that will hold the wiring harness end, so it does not fall to the ground. I thought about just tying it in a knot around the frame or using a bungie cord and tucking it under the cord. Is there a better solution, do they make some sort of...
  7. 2

    multiple configurations for leaf springs???

    I see pics of leaf springs where the axel is on top of the spring and others where the axel is under the spring. I see the "U" facing up sometimes and sometimes its facing down. Are all of the configurations correct?
  8. 2

    no cotter pin?

    I didn't see 2 teeth I only saw 1. I do have a zerk fitting on the end of my spinal and a dust cover that says SUP-R-LUBE
  9. 2

    no cotter pin?

    I went to disassemble my trailer hub and stopped. I couldn't find the cotter pin. There appeared to be a flat 1/4 inch strip of metal keeping the castle nut from moving. It was in the same place where a cotter pin would be. It appeared to keep the castle nut from moving. I couldn't get the...
  10. 2

    Road King rehab

    since my leaf springs are flatted out, how do I measure for length? from the center of the bolt hole to the far side of the bracket is 24 1/4. Will this spring be ok? https://www.boattrailerparts.com/25-inch-5-Leaf-Slipper-Spring-1200lb-Capacity_p_901.html Also how are the U bolts measured?
  11. 2

    Road King rehab

    I picked up a 2008 Road King boat trailer RKG17WV The springs are shot, no question those need replaced. The Hub looks to be leaking from the back. How do I tell if the axel is still good. Will every hub fit on my axel spindle? I am hoping I can just replace the springs and the hubs. Is...
See more
Top