so i went to go start up the boat the other day and i wasnt even able to trim the motor up off of the "kickstands". it made a light clicking sound that came from the trim (up and down) relays. sounds like the motor isnt getting the correct voltage to fully power the relay, so the relays just...
so i just went down to my boat which is stored at the marina (dry and on a trailer, but near the ocean) and its amazing what the weather has done to it in the past couple weeks. so im seriously considering painting my trailer pronto.
since i dont have a ton of rust on it but rather a light coat...
im looking for a cheap reliable compass for my boat. im leaning towards a liquid filled ball. what are your feelings and do you have any suggestions?
im not looking to spend a bunch, just something i can mount to my boat.
is this even possible?
i have severe prop torque issues, my boat leans left hard under power. my props outer edge isnt perfect (could this be adding to the issue?)
but i keep reading that to combat the prop torque you just trim the lower side down a little to balance things out. i also read...
i just picked up a Ray Jeff 550 marine vhf. it works great (i know because we tested it)...
i havent been able to find too much info it or even ray jefferson. i know they are/were owned by jetronics. the radio says its made in japan which make me feel much better about it.
anybody have any...
so i have another thread about my 96 88hp 'rude having a lean sneeze at idle. when i put it into gear (F or R) the rpm drops a little more and then when it sneezes,misses, backfires the motor doesnt have enough rpm in it to catch itself and itll die.
if this infact lean sneeze, would running a...
i was thinking about getting my trailer painted. i have minimal rust on it so i want to address it sooner than later. do autobody shops paint trailers? just wondering because you can get a car sprayed for a couple hundred bucks why not a trailer?...
of course id have them use a different paint...
1996 88hp spl w/ electric trim&tilt.
motor is stalling when i get back to the no wake zone after a little bit of cruising. i just had the annual service too. they did a link and sink on it and checked out the carbs and jets.
it does seem to run a bit warmer than before but the motor "pees"...
i need a pair of covers for my trailer. one cover is completely broken and the other doesnt look too good. it spews grease all over the wheel.. where can i get some new covers? i can only find them as a whole set.
i have a 90 evinrude 88spl but i think the previous owner changed the controls... i only had one key and i have misplaced (lost) my keys. i was able to get the spare for the trailer lock so i could move the boat into the garge but now i dont have a key to the boat. ive attached a photo of the...