Have a 1990 Four Winns Horizon 200 with OMC Cobra 5.7. Recently started taking on water. I had the bellows, shift cable and gimbal replaced last season, I double checked bellows and all hoses and clamps and everything looks sound. Any ideas of how to locate the leak and or some basic process...
1990 OMC Cobra 5.7
In the process of converting over to electronic ignition with hot spark module and pertronix flame thrower 1.5 ohm coil. I got everything installed and using my stock coil and got the timing set to 8 degrees BTDC. It was running great but I took two additional steps that...
I have done several searches on painting an outdrive and found quite a lot of information but one thing isn't clear.
After the zinc chromate primer...do you put the top coat on after it becomes tacky or allow it to fully cure? Any other tips always welcome
I have a 1990 OMC cobra 5.7, the ESA is not working, when I manually engage it there is no change in the engine RPMs which explains why it is hard to get it out of gear.
I have done some reading and see that there are a couple of options however I can't locate the correct part. It seems the...
I am rebuilding the carburetor on my 1990 Cobra 5.7, I had hoped Napa could find a part number for a rebuild kit but no joy. I carried the carburetor into Napa and they could not find it in the Holley book either.
Anyone have any idea how/where I can get the P/N for the carburetor rebuild kit?
I have a 90 Four Winns Horizon 200 with an OMC 5.7. I have had problems with the shifter, it is difficult to get it to go into neutral, when the shifter in in the neutral position sometimes the boat is still in forward or reverse and you have to shake the shifter to get it to come out of gear...
I am looking to put a Bimini on my 90 Four Winns Horizon 200. Here on Iboats marine store it shows a top 79-84" wide X 36" tall X 6' long.
1) this seems way to short in height unless the top were mounted to the top of the windshield. if it is mounted to the top of the windshield it will be a...
When I winterized my boat last September I had a real pain with the oil change and I want to make sure I get it all right before I put it in the water this year.
For reference the boat is a 90 Four Winns Horizon 200 with a 5.7 OMC Cobra
The previous owner gave me a top side oil removal pump...
I have an 1990 OMC 5.7 "PWS" model
The engine does not want to idle especially when cold. I find my self with it on the trailer warming for 5+ minutes but even after running across the lake to normal operating temp it still does not idle well, it just barely stays alive at idle after...
My manual says use OMC oil filter 173233 does anyone know how to find the delco or other equilavent?
On the fuel filter it says OMC 174144, same question, how can cross this to another brand.
Last the Manual says to use SAE 30 oil, I thought this was odd but was wondering if anyone could...
I am just about to pull the trigger on a new custom fit cover from Endura cover or Carver. Can anyone who has purchased from them please give me your opinion on their products and genreal experience with the company?
other options include Westland, Taylormade and Shormaster - all vendors here...
I have a 1990 Four Winns Horizon 200 and am shopping for a cover. I have read tons of threads to the point that my eyes are red but I still don?t have then answer. The consensus seems to be that Sunbrella covers are the best out there, I just can?t pony up 6+ bills for a boat cover.
What is...
Just got a boat with a 1990 OMC Cobra 5.7, I think it is 260 HP but it does have the 4 barrel holley carb which I think was an option so it could be slightly higher HP.
I got it from a 1 owner and he has never had any problem with the boat other than routine maint
Can anyone please let me know...
