one coil wire from my 84 140hp came undone and i want to replace it. i have 2 90hp rudes an 82 and 88 the coil packs have different numbers 582508 on the 90s and 582106 on the 140 are these coils interchangable? Thanks in advance
i have a 72 winner 15ft runabout with a 90hp. Wide open the boat bow digs like crazy i am wondering if it is poor hull design or is the motor to big for the boat, the boat is rated up to 80hp. i have no idea on this matter so any help would be great .. Thanks
my 82 90 Evinrude idles good when the idle speed is high but when u start to lower it , it start missing and then stalls out.... the carbs were just rebuilt .... thanks in advance
my 140 evinrude runs good on land at idle ..when revving the motor by hand if i try to revv it up slowly it gets to a certain point and then starts bogging and missing and it stalls out.. but when revving it fast it runs fine and and goes back to idle with no problems... the carbs were ripped...
i have a 83 140hp evinrude that will not open up at full thottle unless u push the choke in but this can be only done for a little bit and after about 2 min pushing the choke doesn't do anything.. i have cleaned the carbs 3 times and rebuilt them once i also cleaned and rebuilt the fuel pump...
i have a 83 140hp evinrude that will not open up at full thottle unless u push the choke in also this can be only done for a little bit and after about 2 min pushing the choke doesn't do anything.. i have cleaned the carbs 3 times and rebuilt them once i also cleaned and rebuilt the fuel pump...
i have a 82 90hp evinrude i was using it today and the motor had a little virbration to it and i didn't think it was serious .. but ten minutes later after leaving a friends dock at low speed before plaining off the motor started to virbrate very badly and it turned off ..not knowing what it...
