Double check guide for shifter as others mentioned, that in combination with a proper alignment it should slide on easy. If everything is good with the shifter then you need to align gimbal bearing
Ended up sticking a 6 gallon aux tank with fresh non ethanol fuel to run and the boat ran better but still did not resolve the top end fall off. I had my wife pump the bulb as we were WOT and I feel like it did improve the symptom but it is hard to tell as it is such a minor bog to begin with...
Very excited! Just picked up this KL 180cc. My first center console boat and came along with a brand new bimini, aluminum trailer, and a real nice Hummingbird.
I know the KL boats aren't the fanciest but she sure is pretty from the outside!
Anyone else have experience with these boats? The...
It's not premix, it is oil injected. I will be going through the system with the manual when it comes in and make sure the ratio is adjusted properly if that is something that is possible
PO installed new impeller, it pisses strong. PO also said he installed a new fuel pump. Visually it looks new, I can pull it apart if moving to a new aux fuel tank + new plugs and wires doesn't help anything. That is going to be my next step.
I have not directly tested oil injection but when I...
Thanks for the response. I was thinking the same thing.. If PO says he went through the carbs I better make sure it was done correctly.
When I mean "falling off" I mean the boat will get to say 4500RPM and then drop back down to 4000RPM, even if you keep adding throttle. I agree it does sound...
Hey everyone, picked up a new to me 2003 Key Largo 180cc. Super clean boat and came with the 115 2 stroke Mercury.
The motor idles perfectly and has great holeshot and does not bog down at all.
However, upon pushing at higher RPM, the boat feels like it is surging or will not hold high RPM. It...
If the tool goes in and out easy and your outdrive goes on easily then it is fine. If you have trouble getting your outdrive back on, you need to check alignment
Take a hammer with the alignment tool fully installed and tap it in the direction you need to go. The gimbal bearing has some extent of "gimbal" to it and you need to set it after install. You should not need to adjust your engine