Current visitors

Home
Members

airshot's latest activity

A

airshot replied to the thread Help me identify whether I have a 1" or 1 and 1/8" shaft.

Depends being on how accurate your measuring is....3 1/4" equals a 1.034 dia. Shaft........you need a 3.125 circumference to get closer...

Jun 21, 2025
A

airshot reacted to MikeSchinlaub's post in the thread TRANSOM ISSUES!!!! with Like.

The top is usually the last place to get wet, and eater will wick into dry areas. The only reliable fix is to replace the whole transom.

Jun 21, 2025
A

airshot replied to the thread Takes on water over the transom while loading and unloading.

What else is in the back under the well that has weight ? Batteries, fuel tank etc ? Should be drain holes to allow any water back...

Jun 21, 2025
A

airshot reacted to cyclops222's post in the thread Nosing down with Like.

Hooks can be caused by allowing TOO MUCH of a boat to hang out past the trailer supports.

Jun 21, 2025
A

airshot reacted to redneck joe's post in the thread Nosing down with Like.

To bondos point.

Jun 21, 2025
A

airshot reacted to Bondo's post in the thread Pressed-in Zerk grease fittings with Like.

Ayuh,....... 1/4-28 for the small ones, 1/8-pipe for the big ones,....

Jun 20, 2025
A

airshot replied to the thread 1987 mercury 45hp classic 50 shut off in the middle of running.

Does this motor have a CDI box ? The reason being is years back I had the same issue with an OMC outboard. As a last result, we put...

Jun 19, 2025
A

airshot replied to the thread Short vhf antenna.

Move the antenna mount so it can be folded down out of your way when you cover it....

Jun 19, 2025
A

airshot replied to the thread Just keeps going right.

Did you adjust in the correct direction ? Usually only takes a small adjustment at a time. As mentioned it won't stop it all together...

Jun 19, 2025
A

airshot reacted to Chris1956's post in the thread Just keeps going right with Like.

Don't let go of the wheel. Seriously, boats with RH props tend to pull right. The trim tab can be adjusted to compensate, but...

Jun 19, 2025
A

airshot reacted to Chris1956's post in the thread Replacing bow seat foam with Like.

It will only clean it and kill mold and mildew. However, I have never had to replace foam when I made new cushions. Of course, I never...

Jun 19, 2025
A

airshot replied to the thread Replacing bow seat foam.

Will that just clean it, or will that rejuvenate the old foam ? Can't say I have heard that before........curious...

Jun 19, 2025
A

airshot replied to the thread compression on a 9.9 pull start.

Speed of your pull, accuracy of your tester, was the block cold or warm, lots of things can affect the reading...

Jun 18, 2025
A

airshot replied to the thread Lower gear oil drain plug seal for Johnson outboard.

Never had a drain plug come out in my 60 plus years, owned more out boards than I have fingers and toes.....

Jun 18, 2025
A

airshot replied to the thread helm wiring, should be simple, i'm not too bright..

I understand completely....retired tool maker here....electricity is Greek to me as well, except simple stuff....very simple ! My...

Jun 18, 2025

Show older items

Home
Members

Top