Current visitors

Home
Members

alldodge's latest activity

alldodge reacted to jonny rotten's post in the thread No start after engine install. Need Help!!! with Like.

IT RUNS!!! I disconnected the tack wire from coil and tack to test. I also spread the ground pin open on the harness. In my haste I...

May 25, 2025
alldodge replied to the thread Over voltage (again).

How is your keep alive connection wired? The Merc Master Tech that fixed my 1stMate issue also found wiring mistakes by manufacture...

May 25, 2025
alldodge replied to the thread Time to replace tires?.

Fed regulation for tires to have a date code, look on the inside. 4 digites, first 2 digit month, next 2 is year Being the tires are HT...

May 25, 2025
alldodge replied to the thread Over voltage (again).

Agree with Dubs voltmeter will confirm If ALT is putting out more than 14.5V then I would look at connections of sense lead and how feed...

May 24, 2025
alldodge replied to the thread Mercruiser 2.5 ticking sound.

If the noise is coming from a burnt valve than it will show up in a compression test If compression is within 10% all cylinders than...

May 24, 2025
alldodge replied to the thread Mercruiser 2.5 ticking sound.

Opinion If it was a worn cam lope then the noise from that cylinder would be more then others Have you run the motor without the drive...

May 24, 2025
alldodge replied to the thread Mercruiser 2.5 ticking sound.

Doesn't sound like rods, more lifter/valve noise Look at the rocker arm nuts, do they all look to be in about the same place? Might...

May 24, 2025
alldodge replied to the thread 2004 4.3GXI-E running rich.

Fuel rail spec is 50 to 60 psi so your ok there. Try this, turn key on and let it pump up, don't turn key off and watch pressure...

May 24, 2025
alldodge replied to the thread Stuck again.

I've removed several using a Merc tool and never had one even begin to slip. Have had a few tools which should have been rockwell...

May 24, 2025
alldodge reacted to Bondo's post in the thread best way to repair gimbal hing pin threads? with Like.

Ayuh,...... Maybe, never tried it,..... To be sure, find a used freshwater used helmet,....

May 24, 2025
alldodge replied to the thread Stuck again.

Is the tool genuine Merc or something else

May 24, 2025
alldodge replied to the thread No start after engine install. Need Help!!!.

Nice pic but he has a TBV Wire colors are the same, just more of them

May 23, 2025
alldodge replied to the thread No start after engine install. Need Help!!!.

The TBV ignition module has a gray wire (among others) coming from it which goes on the Neg post

May 23, 2025
alldodge reacted to John pettinato's post in the thread 88150a7 Quicksilver Throttle Issue with Like.

I found that the tab has the ability to work on the outter hole by where you pointed your arrow. It doesn’t quite give me 3” of travel...

May 22, 2025
alldodge reacted to nola mike's post in the thread No start after engine install. Need Help!!! with Like.

It would appear that you found your problem. Nothing is connected to the neg coil?

May 22, 2025

Show older items

Home
Members

Top