alldodge's latest activity

  • alldodge
    alldodge reacted to crazy charlie's post in the thread Unusual Bilge pump power issue with Like Like.
    Thanks guys,I will be cutting out any connections and replacing with new connectors.As far as "Black wire disease"..I have seen green or...
  • alldodge
    alldodge replied to the thread Engine Swap.
    The engine coupler is attached to the flywheel LINK can be either item 4 or 9 Look at the splines inside the coupler to make sure the...
  • alldodge
    alldodge replied to the thread what ignition system.
    By the way, have you run through the TBV troubleshooting guide?
    • TBV Troubleshooting.jpg
  • alldodge
    alldodge replied to the thread what ignition system.
    Serial number 0F765981 is manual 17 covering 305 and 350 1993-1997 Part number 8232251
  • alldodge
    alldodge replied to the thread Engine Swap.
    Check/test and maybe replace the bilge pump Maybe the trim sensors Inspect the Y-pipe, Engine coupler, gimbal bearing, top steering pin...
  • alldodge
    alldodge replied to the thread Unusual Bilge pump power issue.
    There is corrosion somewhere and could be on the wire, wire connections or inside the float
  • alldodge
    alldodge replied to the thread Trim pump wiring help.
    Welcome I'm having a hard time understanding just how you have it wired
    • Mercury trim wiring OB.jpg
  • alldodge
    alldodge replied to the thread Starter issue.
    For me it still looks like a full rebuild Need one piston but doing one suggest do all Heads and everything
  • alldodge
    alldodge replied to the thread Time to replace tires?.
    I have them on my car trailer, and had them on my cruiser trailer when I sold it. Their still made and can still be bought
  • alldodge
    If the check balls get stuck open the motor will start to get hot because the balls are bypassing to much water. The check balls are for...
  • alldodge
    alldodge replied to the thread Time to replace tires?.
    I like/dislike bias ply heavy duty Like 6 and 8 ply bias ply ties. Four ply is all that's needed so much heavier and last long time...
  • alldodge
    alldodge replied to the thread Starter issue.
    The cylinder stopped at TDC and is wedged Now that the head is off, trying to rotate the crank should be easier
    • 1piston.jpg
  • alldodge
    I would use what's on the arrestor Brought your serial number up again and it list service manual 8232251 which is number 17 for...
  • alldodge
    alldodge replied to the thread Starter issue.
    my wow was to the OP, not your statement
  • alldodge
    alldodge replied to the thread Starter issue.
    Wow
Top