alldodge's latest activity

  • alldodge
    alldodge reacted to Bondo's post in the thread Plug Wires and coil lead with Like Like.
    Ayuh,...... Welcome Aboard,...... Nothing special 'bout boat plug wires,..... Any coil wire with the right ends will work, just...
  • alldodge
    alldodge replied to the thread Raw water pump.
    Either the pump is defective or bolts/washers not installed correctly
  • alldodge
    alldodge replied to the thread 1972 mercruiser 120 hp.
    One that fits on the drive We need type of boat, what prop is on it now, what is WOT rpm now
  • alldodge
    alldodge reacted to MikeSchinlaub's post in the thread Boats from work. with Like Like.
    So, yesterday sucked. Turns out, I didn't put catalyst in my last cup of resin, and my last layer of mat was still wet. So I had to...
  • alldodge
    alldodge replied to the thread Mercruiser alpha 1 gen 2 alarm sounding.
    There is another temp switch other than the TKS one which causes the alarm to sound thru the ignition module
  • alldodge
    alldodge reacted to Steve51's post in the thread Installing Bravo3 Sterndrive with Like Like.
    The straps on the trim cylinder bars is a good idea, I will try that. I have re-checked and the alignment is slightly off (engine too...
  • alldodge
    alldodge replied to the thread connecting 2 batteries.
    Suggest a Bus Bar https://www.bluesea.com/products/category/18/BusBars
  • alldodge
    alldodge replied to the thread Stingray 180rx water leak.
    Welcome Need to put a float switch on your bilge pump so it turns on automatically Other than putting water in the bilge (I wouldn't do...
  • alldodge
    alldodge replied to the thread Installing Bravo3 Sterndrive.
    The drive shaft isn't making it into the coupler Does the alignment bar go in and out with 2 fingers, and does it go all the way in?
  • alldodge
    alldodge replied to the thread In need of an ECU ‘94 Malibu Echelon.
    OBD DIagnostics has a 861086T1 for 2K, but may also be able to repair yours Oh and a MEFI-1 can be reprogramed so might not need the...
  • alldodge
    alldodge replied to the thread engine shutdown.
    Guess I should add if the distributor wasn't the EST model
  • alldodge
    alldodge replied to the thread engine shutdown.
    That distributor is not designed to be able to create a miss to unload the prop, the shift interruptor turns the dizzy OFF
  • alldodge
    alldodge replied to the thread Tuning vortec 350 replacing old 260 Mercruiser.
    Approx 30* total advance is normal Every 1 mph increase above max hull speed takes a lot of hp Get some slip numbers to find out what...
  • alldodge
    alldodge reacted to redneck joe's post in the thread It is official with Like Like.
    Didn't know i wanted a grandkid, but thought I'd always want a girl so got my wish. Due close to Christmas
  • alldodge
    alldodge replied to the thread engine shutdown.
    What is the motors serial number? What ignition system is installed?
Show older items
Top