Recent content by ambush68

  1. A

    IMPELLER IN OUT DRIVE

    Ok that's what I thought he meant thks.
  2. A

    IMPELLER IN OUT DRIVE

    Thks for your reply. Flushed out for long time already, going to try the hose connection on the interior the prev owner installed. Guy told me no water coming form the propeller.
  3. A

    IMPELLER IN OUT DRIVE

    Ok thks for reply. Lower unit vs out drive? lower unit meaning where the gimble is housed vs just breaking it apart lower down? Sorry new to the lingo.
  4. A

    IMPELLER IN OUT DRIVE

    I LIKE THE CAPS MY EYE SIGHT IS BAD SORRY.. I don't have a heat exchanger? I have a hose connection in eng compartment I'll try that next. Could maybe be the flappers? I'm thinking of dropping the lower unit look for something clogging up the works?
  5. A

    IMPELLER IN OUT DRIVE

    MER CRUISER 5.0 305 CI 2002 MPI 240 HP ( CANT FIND SER NUM) I LOOKED IN THE MANUAL A DONT FIND WHAT I'm LOOKING FOR. Q ? DOES A BRAVO THREE DRIVE HAVE AN IMPELLER IN THE LOWER UNIT? I ASK BECAUSE I AM OVER HEATING DUE TO GROUNDING AND HAVE A NEW IMPELLER, THERMO STAT AND NEW RISER AND...
  6. A

    scrap it or fix it

    I have a 1985 wellcraft 20 ft with a 3.7 merc engine that is frozen. been trying to free it up but no luck so far. my question is: should i scrap it or fix it.? I'm pretty good with tools but would need help to change the eng. I just don't know if its worth it, alot of work to put in a used...
  7. A

    elect choke on carb

    V20 mcm 3.7 242 cd 165 hp The diagram I have shows from choke bottom screw to gnd . gnd? I have purple wire to choke but didn't have a gnd before i had it rebuilt..
  8. A

    elect choke setting?

    I got my new part for the elect choke and yes it was missing a gasket:mad:. Q. Is the setting on this critical to make it work? I know about where to set it but I did not mark the old one:grumpy: Q. Can I start at some position and then move it later? Thanks as always...
  9. A

    My elect choke connection is grounded?

    Checking on why my eng wont start I find that the connection from the wiring harness to the elect coke connector is grounded. I had my carb rebuilt and now wont start I traced it to this point.. Any help would be appr...Thanks In Adv...
  10. A

    Power to fuse panel

    I'm having trouble with wiring at the dash board esp with the fuse panel. Q... Where does the fuse panel get its power from?.. I looked all over some diagrams i can't seem to locate the source of power coming into the panel... 1985 V20 stepup with a 470 mercruiser single bat. volt meter, no...
  11. A

    tourque spec

    1987 mercruiser 3.7 l4 165 HP I need torx spec for the exh manifold thanks
Top