Recent content by Andy_Sydney

  1. Andy_Sydney

    Mercruiser D254 Starter/Alternator wiring help needed

    Re: Mercruiser D254 Starter/Alternator wiring help needed Thanks guys, I found this image showing a similar set up. The brown wire from the starter relay needed to go to the warning lamp pin in order for it to work. The two wires coming out of the alternator needed to go to an ignition...
  2. Andy_Sydney

    Mercruiser D254 Starter/Alternator wiring help needed

    Re: Mercruiser D254 Starter/Alternator wiring help needed The alternator is an aftermarket version... Alternator Mercury Mercurser 805884P 805884T 12176 | eBay I recall it was around $600 for a genuine one. The old alternator: The brown was connected to D+
  3. Andy_Sydney

    Mercruiser D254 Starter/Alternator wiring help needed

    Re: Mercruiser D254 Starter/Alternator wiring help needed Here is the wiring diagram from the manual...
  4. Andy_Sydney

    Mercruiser D254 Starter/Alternator wiring help needed

    Hi, I have purchased a new alternator (from ebay) for my 1993 D254 4.3 Turbo Diesel. The wiring diagram in the manual shows where the colored wires go on the original but give no information about where they should go on the new one. On the wiring harness from the engine i have: Red...
  5. Andy_Sydney

    Mercruiser Bravo alignment problem

    Re: Mercruiser Bravo alignment problem Thanks for the warm welcome and responses guys! I'm picking up the new bolt kit complete with spring washers today and will test with the springs in place. One thing I did read about was the design change: Link My engines are both 1993 D254 models. I...
  6. Andy_Sydney

    Mercruiser Bravo alignment problem

    Hi, I have 2 X Bravo II sterndrives attached to Mercruiser 4.2TD engines. The boat is a Sea Ray 290 SFB. I have been renovating it for the past 2 years. Both engines have been rebuilt from the crank up. Both Bravo Sterndrives and housings were removed, bead blasted and epoxy coated. I...
Top