Re: 96 Glastron SSV 175 - floor / seat mounting repair?
I did bounce on the leg of the outdrive, no flex. I'll pull some bolts out when I get a chance and inspect to be sure. Here's a pic of the floor, like I said not much to see. I'm sure it needs a new floor, just not ready to get into that...
Re: 1996 3.0LX Mercruiser Thermostat & Housing question
FYI, in case anyone else goes through this, the original thermostat is much smaller diameter. The correct part # for the new housing is 807252-1 (Sierra #18-3551) the one that came with it is 807252-2 (160). I checked Napa but it was...
Hey guys, problem started with the temp gauge not working. The gauge itself checked out so I bought a new temp send sensor, installed it, overtightened it putting it in and cracked the housing. Before It started leaking too bad I ran the engine but the gauge didn't move. Not sure if I looked at...
Hey guys, just bought this boat last week. Took her out Sunday and found a few things I need to repair. The driver seat screws pulled out of the floor. Just wondering if I could use toggle bolts or something to re-install or is the fuel tank in this area? Don't want to drill into that. Looked in...
