Arty76's latest activity

  • A
    Arty76 replied to the thread PL-88 load adapter.
    I see in the CDI troubleshooting guide where they show the proper orientation of the flywheel trigger magnet. Is it possible that if it...
  • A
    Arty76 replied to the thread PL-88 load adapter.
    I know, it's just very frustrating.
  • A
    Arty76 replied to the thread PL-88 load adapter.
    Sounds so easy for you to spend my money😉, but yeah, I'm about to order one. Thanks
  • A
    Arty76 replied to the thread PL-88 load adapter.
    No, there isn't.
  • A
    Arty76 replied to the thread PL-88 load adapter.
    It beeps one time, I'm not sure about diagnostics, or ecm
  • A
    Arty76 replied to the thread PL-88 load adapter.
    If I disconnect the main wiring harness, and still have no spark, doesn't that eliminate the shift switch, the safety lanyard switch...
  • A
    Arty76 replied to the thread PL-88 load adapter.
    Even if the coil is bad, shouldn't I be able to get a voltage reading at the primary lead where it attaches to the coil?
  • A
    Arty76 replied to the thread PL-88 load adapter.
    That's very true about the new components, but I'm confident it's cranking fine, I cleaned all the connections when i put the new...
  • A
    Arty76 replied to the thread PL-88 load adapter.
    I've read at least 250 rpm, my starter is brand new.
  • A
    Arty76 replied to the thread PL-88 load adapter.
    I've been dreading these electrical/electronic issues for a long time, expecting them the older my engine gets because I'm not very good...
  • A
    Arty76 replied to the thread PL-88 load adapter.
    Thanks so much, so when it says to check the dva "connected", do I pierce the wires with the meter leads?
  • A
    Arty76 posted the thread PL-88 load adapter in Johnson & Evinrude Outboards.
    I have a 1995 Johnson 200hp Venom with no spark on all cylinders, the stator is new, the timer base dva output is .5 -.8 volts. To check...
  • A
    Arty76 replied to the thread 1998 evinrude 225 ocean pro help #2!.
    My stator is new, I'm questioning the timer base and power pack, I've tried two other timer bases, besides my original, I tested...
  • A
    Arty76 replied to the thread 1998 evinrude 225 ocean pro help #2!.
    The loose magnets you're talking about are the ones that go around the stator, or the timer base magnet? Is the timer base magnet...
  • A
    Arty76 replied to the thread 1998 evinrude 225 ocean pro, no spark! Help!.
    Sorry this is long winded, but my starter crapped out, finally got a new one yesterday, so I know it's cranking fine. But still no...
Show older items
Top