I have a 1989 Force 50hp that I've been messing around with for a couple of months now. I've finally got it idling, cooling, and had used it 3 or 4 times with minor issues until last week. While cruising at full throttle, which is about 25-27 mph the engine suddenly slowed down to about 5-10...
When I got the motor it would run but not idle or cool(no water out of the exhaust).
I've since got it to idle and added a tell-tale to let me know it is peeing/cooling. However when it's running at idle it won't pee, but if I give it a little throttle it will pee out the exhaust great and the...
As the title reads I can't for the life of me get the foot to go back on. I've took it off now 3-4 times with out any issues getting it back one trying to correct my cooling issue.
I recently bought a new water pump and have replaced it, but for some reason the foot will not slide back in all...
I've been messing with the a 1989 Force 50hp now for a little while that has not been cooling properly. I noticed when I pulled the water pump housing to replace the impeller the housing was beat up and even had a hole all the way through it. I'm prettysure this is not supposed to be there...
The top of the hydraulic needs resealed from the looks of it and it looks as though the hydraulic arm is bent a little....I'm assuming from the preivous owner.
Can this be replaced easily when being resealed?
I should add the motor goes up and down fine for the most part except when trimming...