Recent content by banki_21

  1. B

    Water Impeller 90hp Jet

    I need to change out my water impeller, have done it on my 6hp so I'm kinda familar but with the jet I'm not sure wether I have to take the shoe and the impeller off to unbolt the jet kit, because as of right now the impeller will not come off so hoping to save a trip down to the local outboard...
  2. B

    Tiller Throttle Cable

    I did a conversion from remote to tiller on my '92 Evinrude 90hp Jet, and I'm wondering if there is a way to get more movement in the throttle cable? When I hook the cable up it and twist the throttle, I'm still about a quarter inch short on the roller for it to be opened up all the way. Any...
  3. B

    1993 6hp Evinrude running probs

    Hello all, I have been battling my 6hp evinrude for little while now my problem is I can not get my motor to idle down and stay running, also the motor is slow to react when I twist the grip from low rpm to high rpm. I have re-built the carb, installed new water impeller and a new fuel pump. I...
  4. B

    Erratic Tach, overheat alarm

    I was wondering if a bad battery connection could cause the overheat alarm(constant beep) and an erratic or dead tach? <br /><br />As I attempted to start my motor, it barely kicked then nothing would happen when i turned the key, I also noticed a small spark on the negative post where a wing...
  5. B

    Help with rectifier

    I have a 1991 90hp Evinrude(E90JLEIE), and was wondering if I ordered the correct rectifier.<br /><br />I openeded up my cover and couldnt find anything similar to the one I purchased( rectifier I purchased )<br /><br />Can anyone point me in the right direction, or did I buy the wrong one? I...
  6. B

    rpm drop and rise, rough idle

    I have a 90hp Evinrude just had the carbs rebuilt about two weeks ago, and yesterday all of the sudden I go to get on plane and my engine bogs down to 1200 rpms less than wot then jumps back up, and continues this process, its acting like its out of gas. Also it idles rough, coughs, spits and...
  7. B

    frozen impeller

    My Evinrude 90hp/65 jet impeller is frozen, I tried knocking it loose but don't want to really whack it too hard and breaking something else in the process. <br />I need to take it off to re-shim it since it's never been done in the ten years of its existence.
  8. B

    Fuel Starvation?

    Hello all<br />I have a 91 evinrude v4 90hp, with compression @ 150 on all 4. The motor runs almost perect except for the fact it will not go past 4700 rpm's. I have decarbed it once and that really didn't do much for it but I have noticed when I push the choke in my engine comes to life like...
  9. B

    low idle adjustment on 91 6hp evinrude

    Is there a screw or anything to adjust the idle at low speed, seems like it wants to die when running a low speed or will completely die. Any help would be greatly appreciated.
  10. B

    Another question about loss and gain of rpms

    I just had my 1991 Evinrude 90/65 pump tuned up by a local OMC dealer. He said it was running top notch but I took it in the water and yes it was running smooth but still I am short 600 rpms of where I should be running at WOT. But when I push the choke in I kick up to where I should be, I am...
  11. B

    Fuel leaking out of lower unit '91 6hp 'rude

    I was trolling the other day and the engine flooded out real bad, I replaced the spark plugs and gapped them. I haven't been able to start it since it died out in the water. It appears that I am getting no spark and when I am trying to start the motor, it turns over fine, also it leaks fuel out...
  12. B

    Evinrude 90/65 jet won't reach max rpm

    I was trolling the other day and ran my evinrude 90/65 jet for about 3 1/2 hours at low speed, my jet ended up getting clogged with grass and seaweed. I pulled what I thought was all the junk out of the bottom of the grate and pulled the plugs and replaced them because they were fouled. Now...
See more
Top