Recent content by barmahn

  1. B

    over heats above 3500 rpm

    Mine is driven by the timimg belt on the 125B motor. Is it the whole housing your talking about or just the cam inside of it along with the impeller
  2. B

    over heats above 3500 rpm

    the whole housing or just the impeller?
  3. B

    over heats above 3500 rpm

    I have a 83 byliner with a 125B volvo motor in it. The boat runs great when not on plane and runs great when out on plane. My issue is that the boat will overheat when out on plane. Here is what I have all replaced in it to try and fix it. I have replaced the raw waterpump and housing, the...
  4. B

    over heats above 3500 rpm

    Did those along with the hose from the transom to the nipple/elbow on lower unit. Had heat ex changer cleaned and still over heats when out on plane.
  5. B

    over heats above 3500 rpm

    I have replaced the o rings and the white nipple/ elbow and still over heats when above 3500 rpm and out on plane. Any other ideas. Even had heat ex changer cleaned this past weekend and still overheats.
  6. B

    volvo 125B over heats out on plane

    I have a 83 byliner with a 125B volvo motor in it. The boat runs great when not on plane and runs great when out on plane. My issue is that the boat will overheat when out on plane. Here is what I have all replaced in it to try and fix it. I have replaced the raw waterpump and housing, the...
  7. B

    boat wanting to go left when cruising on water

    Thanks I will try that out. I have it going the wrong way according to your video. I have it going to the right instead of the left as I thought it would need to do the same way.
  8. B

    I need a Owners Manuel for 1979 AQ120B

    I just use the green type antifreeze in my 125B. having it mixed at 50/50 with water
  9. B

    boat wanting to go left when cruising on water

    I have an 87 byaliner with a 270 outdrive and the boat wants to go hard left all the time when cruising out on the lake. What would I look for as a cause for this?
  10. B

    trim sensor replacement

    I have a 3355074 trim sensor for a SX Cobra lower unit and I am having issues on finding a replacement for this sensor. Does anyone know of a replacement for it. Any help would be appreciated. Looking at getting the trim gauge to work again and I suspect it is the sensor as the issue and not...
  11. B

    97 four winns motor replacement

    I have a 5.7 liter motor that I need to replace. I found a low hour 94 motor and was wondering if that would work in it as the one that I have in the boat is a 97. It has a carb manifold with a TBI set up on it. I know that the 94 is a carb motor. I was wondering if it would work inplace of...
  12. B

    over heats above 3500 rpm

    I have an 87 bayliner with a Volvo 125 in it and here is the issue that I have been fighting with. The engine runs great and stays cool while I have muffs on it running water through it that way. Once I take it out on the water it will start to heat up and stop pumping water in the fresh water...
  13. B

    Need help! Looking for a replacement starter for a 1986 Bayliner Capri bowrider with a 4-cylinder Volvo Penta inboard outboard motor

    did you find a starter for it yet?
  14. B

    Need help! Looking for a replacement starter for a 1986 Bayliner Capri bowrider with a 4-cylinder Volvo Penta inboard outboard motor

    I found that there is an ID plate on the bell housing. It almost looks like a 125. I have an 87 with a 125 in it. I can take a picture of the plate on where it is at tomorrow if you still haven't found it.
  15. B

    volvo AQ125B overheating while on plane

    Thank you. I ordered the nipple through volvo and will wait on that and then if it continues will try the o ring. I do have a service manual as it came with the boat when I bought the boat used.
See more
Top