Recent content by bcook204

  1. B

    Prop spinning

    Hi All, I have a 1990 Evinrude V6 150hp. I just replaced the water pump, put everything back, runs and pees well. But now the prop spins when in neutral. What did I do wrong and how do I fix it. By the way it was the 1st time replacing water pump by myself. TIA
  2. B

    Exhaust cover gasket leak

    Hi All, I have a 1990 Evinrude 150xp v6 model: E150STLESB. It has a small leak coming from the bottom right corner of the exhaust cover. It is very minute a drip every ten seconds maybe. I had one mechanic tell me not to worry its just a little water and is not bad enough to replace gaskets...
  3. B

    1990 evinrude burning rich

    Hi all, I have a 1990 Evinrude model: E150STLES. Towards the end of this years season it started smoking bad at idle and when I shut it off and turn it back on when warm. Bluish smoke like it's burning rich. I know 2 strokes are suppose to smoke but this is to much for this engine. It never...
  4. B

    1990 evinrude vro fuel pump

    Hi All, I have a 1990 Evinrude model E150STLES. I need to replace the vro fuel pump, Could someone tell me which vro to purchase. I did the research and it seems that model 5007423 is the one I should purchase. But my brother says it model 5007420 because it is 4 wire. I did look at the...
  5. B

    EVINUDE HOSE AND CLAMP SIZES

    Hi All, For the 1st time I am going to rebuild my carburetors myself this winter. I am also going to replace fuel filters and hoses as well. I have 1990 Evinrude 150 hp V6 , model # E150STLESB. On the parts list for VRO2 there are hoses, part # 8 and #23. Could someone please tell me what...
  6. B

    GAS SMELL

    HI All, I have a 1990 Ranger Comanche 361V . When my boat is sitting I often smell gas odor coming from cowl vent near back of boat . It always the vent by the gas line. One is pointed forward and the other is pointed rearward. I changed all the gas lines from the two tanks to the engine...
  7. B

    Help with trailer wheel size

    Hi all, I have a 18ft, 1990 Ranger 361V Comanche with original trailer. I just had a blow out on one of my trailer tires. I changed the tire, came home to research what tire to buy. This is my 1st time. I quickly found out that I have automobile tires on and not trailer tires. Could someone...
  8. B

    PROP FOR 1990 EVINRUDE

    Hi all, Could someone tell me what size prop is suggested for a 1990 Evinrude XP150 V6 VRO on a 1990 Ranger Commanche 361V? I would like to purchase a aluminum prop. Also what brand do you prefer?
  9. B

    GREASE FITTING 1990 EVINRUDE

    Hi All, I have a 1990 evinrude 150 hp v6. Could someone tell me where all the grease fittings are? I found 2 for the tilt tube. I also see 2 areas that should be greased on the left right pivots when I turn the steering wheel. One is upper and one is lower. I found the fitting for the lower...
  10. B

    1990 Evinrude comression

    Hi All, I have a 1990 Evinrude 150 hp V6 outboard that I had rebuilt before I winterized it in November. I broke the engine in and have no more than 5 hours of use on it. I then winterized the engine and 2 weeks ago I dewinterized it by taking it out for a couple of hours. I then checked the...
  11. B

    Push to choke ignition problem

    I recently installed a new push to choke ignition (508180). I thought I was being real careful about the wiring. But now the front trim does not work. The fishfinder on front does not work. The trim button on engine and and gear shift does work. The kill switch works also. Did I get...
  12. B

    FOGGING OUTBOARD

    Hi All, This is my 1st year owning a boat and decided to winterize my 1990 Evinrude 150 hp V6 by myself. Here's what I did. Could you tell me if I did it correctly. 1. Ran engine for 20 minutes to warm up 2. Turn engine off and attached fogging can to schrader valve. 3. Turned engine back on...
  13. B

    Ignition switch for 1990 Evinrude 150 hp

    Hi all, I have a 1990 Ranger Comanche 361V with a 1990 Evinrude 150 hp engine. I am in need a a ignition switch (push to choke). Does anyone know what model it is. Should I contact Ranger or Evinrude for it. I seen many of them on the internet (after market) but do not know which one to...
  14. B

    1990 evinrude 150 hp v6 starting

    HI all. I have a 1990 evinrude 150 hp v6 that runs absolutely great. Except when I need to start it up after warm up I need to trim it up a little so it will start. I have no problem during this but just wanted to know if this is normal.
  15. B

    1990 EVINRUDE SPARK PLUG

    Hi All, Could someone tell me what spark plugs I need to purchase for my 1990 Evinrude 150 hp V6 VRO model # E150STLES.
See more
Top