I am redoing a 1970 Kayot pontoon and it is time for the deck to go on to the alum frame. Orginally it was only bolted around the outside edges of deck to the frame. Between the four foot sheets of plywood there were these JH clips. I am not sure what to call them. The wood slide into both ends...
I am redoing a 1970 Kayot pontoon and it is time for the deck to go on. Orginally it was only bolted around the outside edges of deck to the frame. Between the four foot sheets of plywood there were these JH clips. I am not sure what to call them. The wood slide into both ends of the H and the J...
Upon reading some of the forums my motor must be the Selectic Shift because it only has one control arm for throttle. I have the wiring diagram for this motor but it only shows power going from key to a box called "Leads to shift selector" with three wires. One wiring being power the other two...
Does anyone know what the external part of the harness is called or where to find it for an 68 evinrude. The internal harness is all ok, (assumed from previous owner saying used to run). Trying to find what to wire external harness to for key on, key off, and start positions. The harness has...
I was given a 1968 40 HP EVINRUDE Outboard 40872 D but the wiring harness was cut that goes to an ignition box I assume. Can I just jumper the wires to a key starter or will need more. Does anyone have a color code for the wiring. Lost and new!! Thanks for any help. Email me at...
